Background: So far, the effect of graphene oxide (GO) and reduced graphene oxide (rGO) in rubber matrix has not been well established.

Rubber blends based on ethylene-propylene-diene-monomer (EPDM) rubber and fluoroelastomer (FKM) having various blend ratios were prepared. The phase morphology, cure characteristics, hardness, tensile and dynamic viscoelastic properties of the blends were investigated. The cure rate of the blends increased, while the crosslink-density decreased as the FKM content increased. The hardness, tensile strength and elongation at break, and storage modulus (E') increased with increasing FKM loading. A typical incompatible blend behavior was found by observing two distinct tanδ peaks corresponding to EPDM and FKM. Based on the morphology investigation by scanning electron microscopy (SEM) and energy dispersive x-ray spectroscopy (EDS) analyses, a typical 'sea-island' phase morphology was observed for the EPDM/FKM blends. As the FKM loading was increased to 50 phr, the EPDM was found to remain as the continuous phase. At the 80 phr of FKM, a co-continuous phase was observed and the phase inversion was observed at 90 phr of FKM.

This study aimed to develop materials to compensate for problems of restoration for lost parts and material problems in the conservation treatment. First, there are several problems with existing materials as follows: secondary damage due to the high shrinkage rate and low adhesive strength, sense of difference due to the severe yellowing, remelting due to irreversibility of materials, processability due to the high strength, sag due to the prolonged setting time in the work process and surface contamination of artifacts due to tools or gloves. In order to solve these problems, this study set developmental goals after understanding the types and physical properties based on epoxy resin among the currently used restoration materials of pottery and earthenware. The developed epoxy resin is epoxy putty, which is cured within 5 minutes, for earthenware restoration. In the earthenware restoration method, the epoxy putty enhanced the workability by quickly curing in paste form and compensated disadvantages such as surface contamination. In addition, the use of white micro-balloon for the epoxy stock solution made coloring easier and weight lighter, and a restoration material with low shrinkage and superior processability was developed.