Flexible thin film super-capacitors with the silver paste current collector were printed and their electrochemical characteristics were investigated to apply for a low cost solution-based printing process. The silver paste current collector was printed on a flexible Polyethylene Telephtalate (PET) substrate and the activated carbon electrode was printed in a sequence by using a mature screen printing. In experimental evaluation, three silver pastes with different solid contents were prepared and compared because sheet resistance depended on the thickness of the current collector. By using the confocal image, the thickness of the printed electrode of the activated carbon was measured to be 27.8 microm. Cyclic voltammogram, the specific capacitance and impedence together with capacitance retension were examined to determine the performance of the printed super-capacitor. The highest specific capacitance of 53.05 F/g at a scan rate of 10 mV/s was obtained. The measurement results show that the printed super-capacitors with the silver paste current collector have a great potential to apply for wearable electronics and protable electronic devices.
The one of the most important issue in roll-to-roll gravure printing is increase of ink transfer ratio or printability. As the result of high ink transfer ratio or printability, we can assess the quality of the printed patterns. The rheological properties are the important factors for the printability of electrodes patterning. In this study, the rheological properties of conductive ink are controlled by adding the solvent. The inks with different rheological properties are used for the patterning of the electrodes of 100µm by gravure printing equipment. The various printing speed, which also affect the rheological properties of conductive ink, is applied and the printed patterns are compared for their width and aspect ratio. Decreasing in the ink viscosity as well as increasing in the printing speed decreases the printability in gravure patterning, which shows that the rheological properties are important factors for the printability of gravure patterning.
This paper challenges the fabrication of a thin film energy storage device on a flexible polymer substrate specifically by replacing most commonly used metal foil current collectors with coated current collectors. Mass-manufacturable spray-coating technology enables the fabrication of two different half-cell electric double layer capacitors (EDLC) with a spray-coated silver paste current collector and a Ni foil current collector. The larger specific capacitances of the halfcell EDLC with the spray-coated silver current collector are obtained as 103.86 F/g and 76.8 F/g for scan rates of 10 mV/s and 500 mV/s, respectively. Further, even though the half-cell EDLC with the spray-coated current collector is heavier than that with the Ni foil current collector, smaller Warburg impedance and contact resistance are characterized from Nyquist plots. For the applied voltages ranging from À0.5 V to 0.5 V, the spray-coated thin film energy storage device exhibits a better performance.
:The supercapacitors were fabricated using silver (Ag) nano paste and activated carbon paste on the polyimide (PI) film and 5% potassium polyacrylate (PAAK) was used for gel electrolyte. In this paper, the current collector film and the electrode film were fabricated using screen printing. The thickness of printed silver paste was 7.3 µm and the sheet resistance has the range of 5-7 mΩ/square. An activated carbon with a surface area of 1,968 m 2 /g, an electronic conducting agent (SUPER P, TIMCAL) and poly (4-vinylphenol) were mixed in 2-(2-buthoxyethoxy) ethyl acetate (BCA) with a ratio of 7:1:3 to fabricate the electrode paste. To analyze electrochemical characteristics, cyclic voltammetry was performed to evaluate the stability of the devices under the voltage range of -0.5-0.5 V. The calculated specific capacitances were 44.04 and 8.62 F/g for 10 and 500 mV/s scan rates, respectively.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.