No abstract

*Graphical Abstract (for review)Cryotripic gelation technique allows the synthesis of solid and soft macroporous gels Textural characterisation of cryogel in native superhydrated state with noninvasive methods Adsorption and diffusion characteristics of macroporous cryogels with respect to macromolecules and cells Theoretical modelling of adsorption from aqueous media *Highlights (for review) Please find the revised manuscript entitled "Cryogels: morphological, structural and adsorption characterisation" by Vladimir M. Gun'ko, Irina N. Savina, Sergey V. Mikhalovsky to re-consider for publication in the "Advances in Colloid and Interface Science"The paper was completely edited and changed according to reviewers comments.Sincerely yours, Prof. V. M. Gun'koCover Letter ABSTRACTExperimental results on polymer, protein, and composite cryogels and data treatment methods used for morphological, textural, structural, adsorption and diffusion characterisation of the materials are analysed and compared. Treatment of microscopic images with specific software gives quantitative structural information on both native cryogels and freeze-dried materials that is useful to analyse the drying effects on their structure. A combination of cryoporometry, relaxometry, thermoporometry, small angle X-ray scattering (SAXS), equilibrium and kinetic adsorption of low and high-molecular weight compounds, diffusion breakthrough of macromolecules within macroporous cryogel membranes, studying interactions of cells with cryogels provides a consistent and comprehensive picture of textural, structural and adsorption properties of a variety of cryogels. This analysis allows us to establish certain regularities in the cryogel properties related to narrow (diameter 0.4 < d < 2 nm), middle (2 < d < 50 nm) and broad (50 < d < 100 nm) nanopores, micropores (100 nm < d < 100 m) and macropores (d > 100 m) with boundary sizes within modified life science pore classification. Particular attention is paid to water bound in cryogels in native superhydrated or freeze-dried states. At least, five states of water -free unbound, weakly bound (changes in the Gibbs free energy G < 0.5-0.8 kJ/mol) and strongly bound (G > 0.8 kJ/mol), and weakly associated (chemical shift of the proton resonance  H = 1-2 ppm) and strongly associated ( H = 3-6 ppm) waters can be distinguished in hydrated cryogels using 1 H NMR, DSC, TSDC, TG and other methods. Different software for image treatment or developed to analyse the data obtained with the adsorption, diffusion, SAXS, cryoporometry and thermoporometry methods and based on regularisation algorithms is analysed and used for the quantitative morphological, structural and adsorption characterisation of individual and composite cryogels, including polymers filled with solid nano-or microparticles.

The wearable artificial kidney can deliver continuous ambulatory dialysis for more than 3 million patients with end-stage renal disease. However, the efficient removal of urea is a key challenge in miniaturizing the device and making it light and small enough for practical use. Here, we show that two-dimensional titanium carbide (MXene) with the composition of Ti 3 C 2 T x , where T x represents surface termination groups such as −OH, −O−, and −F, can adsorb urea, reaching 99% removal efficiency from aqueous solution and 94% from dialysate at the initial urea concentration of 30 mg/dL, with the maximum urea adsorption capacity of 10.4 mg/g at room temperature. When tested at 37 °C, we achieved a 2-fold increase in urea removal efficiency from dialysate, with the maximum urea adsorption capacity of 21.7 mg/g. Ti 3 C 2 T x showed good hemocompatibility; it did not induce cell apoptosis or reduce the metabolizing cell fraction, indicating no impact on cell viability at concentrations of up to 200 μg/mL. The biocompatibility of Ti 3 C 2 T x and its selectivity for urea adsorption from dialysate open a new opportunity in designing a miniaturized dialysate regeneration system for a wearable artificial kidney.

No abstract