No abstract

Membrane-based separation technologies are attractive to remediating unconventional water sources, including brackish, industrial, and municipal wastewater, due to their versatility and relatively high energy efficiency. However, membrane fouling by dissolved or suspended organic substances remains a primary challenge which can result in an irreversible decline of the permeate flux. To overcome this, membranes have been incorporated with photocatalytic materials that can degrade these organic substances deposited on the surface upon light illumination. While such photocatalytic membranes have demonstrated that they can recover their inherent permeability, less information is known about the effect of photocatalysis on the kinetics of the permeate flux. In this work, a photocatalytic mesh that can selectively permeate water while repelling oil was fabricated by coating a mixture of nitrogen-doped TiO2 (N-TiO2) and perfluorosilane-grafted SiO2 (F-SiO2) nanoparticles on a stainless steel mesh. Utilizing the photocatalytic mesh, the time-dependent evolution of the water-rich permeate flux as a result of photocatalytic degradation of the oil was studied under the visible light illumination. A mathematical model was developed that can relate the photocatalytic degradation of the organic substances deposited on a mesh surface to the evolution of the permeate flux. This model was established by integrating the Langmuir–Hinshelwood kinetics for photocatalysis and the Cassie–Baxter wettability analysis on a chemically heterogeneous mesh surface into a permeate flux relation. Consequently, the time-dependent water-rich permeate flux values are compared with those predicted by using the model. It is found that the model can predict the evolution of the water-rich permeate flux with a goodness of fit of 0.92.

No abstract

Frost is common when a solid surface is subjected to a humid and cold environment. It can cause various inconveniences, complications, or fatal accidents. Water-repellent surfaces have demonstrated an antifreezing capability by enabling the water droplets to roll or bounce off before they freeze. However, these surfaces are often limited by their inability to shed the small water condensates, which can eventually grow and freeze. Recently, surfaces that can rapidly absorb and hydrogen bond with these water condensates have demonstrated significant delay in frost formation and growth. This is attributed to a lower freezing temperature of the absorbed water which makes it stay in a nonfreezing state. Herein, we report a surface with preferential wettability of water over oil (i.e., superhydrophilic and oleophobic wettability) that can significantly delay frost formation. The surface is fabricated by copolymerizing poly(ethylene glycol) diacrylate (PEGDA) and perfluorinated acrylate (1H,1H,2H,2H-heptadecafluorodecyl acrylate, HDF-acrylate) applied to a silane-grafted glass substrate (HDF-PEGDA). An HDF-PEGDA surface can quickly absorb condensed water which enables it to delay frost formation and growth for up to 20 min at a surface temperature of −35 °C. Also, the surface demonstrates that its frost-resistant capability remains almost unaffected even after being submerged in an oil bath due to its in-air oil repellency. Differential scanning calorimetry (DSC) measurements reveal that the significant quantity of absorbed water in an HDF-PEGDA surface remains in a nonfreezing state with a T m value as low as −33 °C. A mathematical model that can predict the time at which the surface begins to be covered with frost is developed. Finally, an HDF-PEGDA is layered with a PEGDA copolymerized with sodium acrylate (Na-acrylate) that enables the continuous release of the absorbed water by posing forward osmotic pressure and regeneration of an HDF-PEGDA surface.