This paper focuses on the structure and performance of the pressure swirl nozzle and the study of liquid atomization. In this study, the atomizer has been designed and some experiments have been performed on it. Since image processing is an efficient method for measuring the size of the droplet and since it considerably reduces the total measuring time and eliminates the subjective observer’s error in sizing and counting spray drops, a digital camera has been used for capturing images and image processing has been done by the MATLAB software. The results show that by increasing the atomization air pressure, the spray angle increases and the droplet’s size decreases. It is concluded that the spray angle is a function of the atomization air pressure and orifice diameter. Moreover, when the distance from the spray centre line increases, the droplet’s average velocity decreases.

Ceramic materials are widely used in impact safekeeping systems. Ceramic is a heterogeneous material; its characteristics depend considerably both on specifications of its ingredients and the material structure completely. The finite element method (FEM) can be a useful tool for strength computation of these materials. In this paper, the mechanical properties of the ceramic composites are investigated, and the mechanical performance modeling of fiber-fortified ceramic matrix composites (CMC) is expressed by the instance of aluminum oxide fibers in a matrix composite based on alumina. The starting point of the modeling is an infrastructure (primary cell) that contains a micromechanical size, the statistical analysis characteristics of the matrix, fiber-matrix interface, fiber, and their reciprocal influences. The numeral assessment of the model is done using the FEM. The numerical results of composite elastic modulus were computed based on the amount of the added fibers and the porosity was evaluated for empirical data of samples with a similar composition. Various scanning electron microscope (SEM) images were used for each sample to specify the porosity. Also, the unit cell method presumed that the porous ceramic substance is manufactured from an array of fundamental units, each with the same composition, material characteristic, and cell geometry. The results showed that when the material consists of different pores and fibers, the amount of Young’s modulus reduces with the increment of porosity. The linear correlation model of elasticity versus porosity value from experimental data was derived by MATLAB curve fitting. The experimental data from the mechanical test and numerical values were in good agreement.