No abstract

A new preparation method for CL-20/HMX (2:1) cocrystal has been established at the laboratory level that is amenable for scale up. Solvent evaporation from a saturated solution of the stoichiometric mixture in the presence of a high boiling antisolvent, comparatively a very efficient and cheaper method, yielded pure cocrystals. Cocrystals were well characterized by spectroscopic, thermoanalytical tools, X-ray diffraction, and microscopic techniques. A correlation of percentage of cocrystal formation with evaporation rate has been obtained through quantitative analysis using Raman spectrometry. An evaporation rate of <1 mL/min consistently produced pure cocrystal confirmed by Raman and powder X-ray diffraction analysis. Thermokinetic analysis suggests the cocrystal to be more stable than CL-20 with an energy of activation of 65 kcal/mol, higher than CL-20 but inferior to HMX. Significant augmentation in the values of k and A over CL-20 justified a faster decomposition rate. Enhanced insensitivity toward friction and impact forces and higher measured velocity of detonation indicate improved performance on incorporation into high explosive formulations.

Multiphase growth during crystallization severely affects deliverable output of explosive materials. Appearance and incomplete transformation of metastable phases are a major source of polymorphic impurities. This article presents a methodical and molecular level understanding of the metastable phase transformation mechanism during crystallization of cyclic nitramine explosives, viz. RDX, HMX and CL-20. Instantaneous reverse precipitation yielded metastable γ-HMX and β-CL-20 which undergo solution mediated transformation to the respective thermodynamic forms, β-HMX and ε-CL-20, following 'Ostwald's rule of stages'. However, no metastable phase, anticipated as β-RDX, was evidenced during precipitation of RDX, which rather directly yielded the thermodynamically stable α-phase. The γ→β-HMX and β→ε-CL-20 transformations took 20 and 60 minutes respectively, whereas formation of α-RDX was instantaneous. Density functional calculations were employed to identify the possible transition state conformations and to obtain activation barriers for transformations at wB97XD/6-311++G(d,p)(IEFPCM)//B3LYP/6-311G(d,p) level of theory. The computed activation barriers and lattice energies responsible for transformation of RDX, HMX and CL-20 metastable phases to thermodynamic ones conspicuously supported the experimentally observed order of phase stability. This precise result facilitated an understanding of the occurrence of a relatively more sensitive and less dense β-CL-20 phase in TNT based melt-cast explosive compositions, a persistent and critical problem unanswered in the literature. The crystalline material recovered from such compositions revealed a mixture of β- and ε-CL-20. However, similar compositions of RDX and HMX never showed any metastable phase. The relatively long stability with the highest activation barrier is believed to restrict complete β→ε-CL-20 transformation during processing. Therefore a method is suggested to overcome this issue.

This article presents the evidence of possible route to the formation of ε-and α-polymorphic phases of 2, 4,6,8,10,4,6,8,10, studied through CL-20 solution using reverse and normal precipitation method. Reverse precipitation with instant addition facilitated with the opportunity to track the crystal phases from their immediate formation to end of phase stabilization. Precipitation under apparent conditions to achieve α-or ε-phases, showed initial occurrence of metastable β-phase and subsequent transformation to the intended stable phases. The β-phase showed sufficiently longer stability while under specified conditions for ε-than in a hydrated medium set to obtain the α-phase.Transformation of fine needle shaped β-CL-20 crystals to uniform diamond shaped α-or bipyramidal ε-habit had been observed to pass through an equilibrium state of dissolution and reprecipitation. This work also elaborates the effect of crystallization methodology on conversion time. Vibrational spectroscopy and microscopic techniques were employed to track the time dependent polymorphic conversions. Drastic reduction in β → ε conversion time, from 160 minutes to 10 minutes could have been affected by using ultra dispersed seed crystals. We thus also demonstrated a hazard free non-grinding method to prepare ε-CL-20 with particle size <10 µm through precipitation and their effect on thermal stability & mechanical sensitivity.

SummaryRing-rearrangement metathesis (RRM) involves multiple metathesis processes such as ring-opening metathesis (ROM)/ring-closing metathesis (RCM) in a one-pot operation to generate complex targets. RRM delivers complex frameworks that are difficult to assemble by conventional methods. The noteworthy point about this type of protocol is multi-bond formation and it is an atom economic process. In this review, we have covered literature that appeared during the last seven years (2008–2014).