Large-scale synthesis of two-dimensional (2D) materials is one of the significant issues for fabricating layered materials into practical devices. As one of the typical III-VI semiconductors, InSe has attracted much attention due to its outstanding electrical transport property, attractive quantum physics characteristics, and dramatic photoresponse when it is reduced to atomic scale. However, scalable synthesis of single phase 2D InSe has not yet been achieved so far, greatly hindering further fundamental studies and device applications. Here, we demonstrate the direct growth of wafer-scale layered InSe nanosheets by pulsed laser deposition (PLD). The obtained InSe layers exhibit good uniformity, high crystallinity with macro texture feature, and stoichiometric growth by in situ precise control. The characterization of optical properties indicates that PLD grown InSe nanosheets have a wide range tunable band gap (1.26-2.20 eV) among the large-scale 2D crystals. The device demonstration of field-effect transistor shows the n-type channel feature with high mobility of 10 cm V s. Upon illumination, InSe-based phototransistors show a broad photoresponse to the wavelengths from ultraviolet to near-infrared. The maximum photoresponsivity attains 27 A/W, plus a response time of 0.5 s for the rise and 1.7 s for the decay, demonstrating the strong and fast photodetection ability. Our findings suggest that the PLD grown InSe would be a promising choice for future device applications in the 2D limit.

Recently, research on graphene based photodetectors has drawn substantial attention due to ultrafast and broadband photoresponse of graphene. However, they usually have low responsivity and low photoconductive gain induced by the gapless nature of graphene, which greatly limit their applications. The synergetic integration of graphene with other two-dimensional (2D) materials to form van der Waals heterostructure is a very promising approach to overcome these shortcomings. Here we report the growth of graphene-Bi2Te3 heterostructure where Bi2Te3 is a small bandgap material from topological insulator family with a similar hexagonal symmetry to graphene. Because of the effective photocarrier generation and transfer at the interface between graphene and Bi2Te3, the device photocurrent can be effectively enhanced without sacrificing the detecting spectral width. Our results show that the graphene-Bi2Te3 photodetector has much higher photoresponsivity (35 AW(-1) at a wavelength of 532 nm) and higher sensitivity (photoconductive gain up to 83), as compared to the pure monolayer graphene-based devices. More interestingly, the detection wavelength range of our device is further expanded to near-infrared (980 nm) and telecommunication band (1550 nm), which is not observed on the devices based on heterostructures of graphene and transition metal dichalcogenides.

Lithium sulfur batteries with high energy densities are promising next-generation energy storage systems. However, shuttling and sluggish conversion of polysulfides to solid lithium sulfides limit the full utilization of active materials. Physical/chemical confinement is useful for anchoring polysulfides, but not effective for utilizing the blocked intermediates. Here, we employ black phosphorus quantum dots as electrocatalysts to overcome these issues. Both the experimental and theoretical results reveal that black phosphorus quantum dots effectively adsorb and catalyze polysulfide conversion. The activity is attributed to the numerous catalytically active sites on the edges of the quantum dots. In the presence of a small amount of black phosphorus quantum dots, the porous carbon/sulfur cathodes exhibit rapid reaction kinetics and no shuttling of polysulfides, enabling a low capacity fading rate (0.027% per cycle over 1000 cycles) and high areal capacities. Our findings demonstrate application of a metal-free quantum dot catalyst for high energy rechargeable batteries.

Amorphous black phosphorus (a-BP) ultrathin films are deposited by pulsed laser deposition. a-BP field-effect trans-istors, exhibiting high carrier mobility and moderate on/off current ratio, are demonstrated. Thickness dependence of the bandgap, mobility, and on/off ratio are observed. These results offer not only a new nanoscale member in the BP family, but also a new opportunity to develop nano-electronic devices.

Two-dimensional layered transition metal dichalcogenides (TMDs) show intriguing potential for optoelectronic devices due to their exotic electronic and optical properties. Only a few efforts have been dedicated to large-area growth of TMDs. Practical applications will require improving the efficiency and reducing the cost of production, through (1) new growth methods to produce large size TMD monolayer with less-stringent conditions, and (2) nondestructive transfer techniques that enable multiple reuse of growth substrate. In this work, we report to employ atmospheric pressure chemical vapor deposition (APCVD) for the synthesis of large size (>100 μm) single crystals of atomically thin tungsten disulfide (WS2), a member of TMD family, on sapphire substrate. More importantly, we demonstrate a polystyrene (PS) mediated delamination process via capillary force in water which reduces the etching time in base solution and imposes only minor damage to the sapphire substrate. The transferred WS2 flakes are of excellent continuity and exhibit comparable electron mobility after several growth cycles on the reused sapphire substrate. Interestingly, the photoluminescence emission from WS2 grown on the recycled sapphire is much higher than that on fresh sapphire, possibly due to p-type doping of monolayer WS2 flakes by a thin layer of water intercalated at the atomic steps of the recycled sapphire substrate. The growth and transfer techniques described here are expected to be applicable to other atomically thin TMD materials.