No abstract

A novel configuration of CVT that contains two cones located in the same shaft face to face is researched about the traction performance under high speed based on the theory of elastohydrodynamic lubrication(EHL). The effects of load, radii of curvature and slip-roll ratio on the traction characteristics and power transmission are analyzed. The results show that with increasing load the traction coefficient enhances close to linearly where the load is not heavy and the minimum film thickness decreases linearly when the inner wheel radii of curvature less than 0.085m. The leftmost position could transmit higher power. The power transmitted improves slightly as slip-roll ratio enhances in an appropriate range.

To calculate the pressure distribution of oil film on spherical port plate of Innas hydraulic transformer (IHT), finite difference method (FDM) based on boundary fitted coordinate (BFC) technique is presented. Spherical curvilinear grid system was obtained with a coincident boundary of irregular physical area. The flux conservation form of Reynolds’ equation was applied as control equation. By FDM, the thickness distribution and pressure distribution of distribution pair were calculated. It shows that BFC transformation method is advantaged to closely simulate the physical domain with complex geometrical boundaries.

A New Complex Crystal [Co(Hdmg)2(Him)2]·(ClO4) (H2dmg = Dimethylglyoxime,Him = Imidazole) Had Been Synthesised in Aqueous Solution and Was Characterized by X-ray Diffraction and IR Spectrum. the Complex Crystallizes in Triclinic Space Group with Cell Constants a= 20.868(7)Å, B=11.408(4)Å, C=15.816(4)Å, α=90.00°, β=116.97(2)°, γ= 90.00°, V= 3355.8(17) Å3, Z=4, F(000)=1732. the Coordination Environment of Cobalt Atom Is a Slightly Distorted Octahedron. the Four Equatorial Donors Are Four Nitrogen Atoms from Two Bidentate Chelate Hdmg Anion Ligands. the Apex Points Are Occupied by Two Nitrogen Atoms from him Ligands. the Co-N(Him) Distance Is 1.930Å, and the Co-N(dmg) Distances Are Varying in the Range from 1.886Å to 1.993Å which Are in Agreement with Corresponding Reported in a Number of other Structurally Related Copper(II) Complexes.

Analysis Methods of Power characteristics for hydraulic pressing of the traction drive device are studied. The operating principle of hydraulic pressing of the traction drive device is analyzed, Probe into the rule of variation of the inner and outer Friction Pairs about the traction coefficient and the transmission ratio, A mathematical model of transmission traction characteristics is built up based of the Elasto-hydrodynamic lubrication theory, to explore the power characteristics of the friction pairs under different slip roll ratio and normal loading force, and the transmission of the input power and output power under different total sliding rate and loading force. The results showed that the transmission power of hydraulic pressing of the traction drive device is increasing when the normal loading force is increasing under some sliding Rate, but the transmission power tend to stable when the shearing stress is close to limiting shearing stress；and with the Sliding Rate increasing the transmission power increase under some normal loading force, but the transmission power eventually tend to stable when the Shearing Stress is close to limiting shearing stress.