Colonoscopy is an effective method for screening colorectal cancer and adenoma, but the adenoma detection rate depends on the quality of bowel preparation. Our study investigates the influencing factors of the quality of bowel preparation before colonoscopy in outpatients and the influence of the number of walking steps on the quality of bowel preparation. We prospectively collected the clinical data of 150 outpatients undergoing colonoscopy in our department in 2019. Ordinal logistic regression shows that the overweight, not drinking, the number of walking steps before colonoscopy, and the time interval between start PEG and colonoscopy (4–6 hours) were independent factors affecting bowel preparation quality. There was a curving relationship between the reciprocal of Ottawa score and the number of walking steps before colonoscopy, and the regression equation is 1/ Ottawa score = −0.198 + 0.062 × ln steps ( p = .035), a minimum of 5,270 walking steps before a colonoscopy is required for a high quality of bowel preparation.

This paper completes a design of power monitoring system of machine tool based on MSP430F149 microcontroller. This system is mainly divided into four modules: the electric energy information input and processing module, electric energy metering operation processing module, Single-Chip Microcomputer system internal data processing module, and PC memory module, respectively. The voltage transformer and current transformer collect voltage signal and current signal respectively, which were inputted deferentially to the ATT7022A voltage channel and current channel, to achieve electric energy information input and processing. The special measure chip ATT7022A measures the three-phase active power, reactive power, apparent power, active energy and reactive energy to meter and operate electric energy. MCU system processing module communicates with ATT7022A chip via the SPI bus interface by using the 16 bit MSP430F149 microcontroller. The establishment of database model and database table using the relatively practical method of entity-relationship achieves PC internal data memory module. In addition, the fabrication of PCB circuit board and software writing are also introduced in detail in this paper.