A simple, handy, reusable, and inexpensive water purification unit including a one-end sealed porous amorphous-silica (a-silica) tube coated with 2 μm of porous TiO2photocatalyst layers has been developed. Both TiO2and a-silica layers were formed through outside vapor deposition (OVD). Raman spectrum of the porous TiO2-coated a-silica glass tube indicated that the anatase content of the TiO2layers of the tube was estimated to be approximately 60 wt%. Developed porous TiO2-coated a-silica glass tube has been assayed for the tube filtering feature againstEscherichia coli(E. coli) solution used as one of the typical bacteria size species or Qβphage also used as typical virus size species and compared with the feature of porous a-silica tubes alone. The tubes removedE. colicompletely from the aqueous suspension which contained 106 CFU/mL ofE. coliwithout UV irradiation. The porous TiO2-coated a-silica glass tube with UV-C lamps successfully reduced the Qβphage amount in the suspension from 109to 103 PFU/mL.

A simple, convenient, reusable, and inexpensive air-and water-purification unit including a one-end sealed porous amorphous-silica (a-silica) tube coated with TiO2 photocatalyst layers has been developed. The porous a-silica layers were formed through outside vapor deposition (OVD). TiO2 photocatalyst layers were formed through impregnation and calcination onto a-silica layers. The resulting porous TiO2-impregnated a-silica tubes were evaluated for air-purification capacity using an acetaldehyde gas decomposition test. The tube (8.5 mm e.d. × 150 mm) demonstrated a 93% removal rate for high concentrations (ca. 300 ppm) of acetaldehyde gas at a single-pass condition with a 250 mL/min flow rate under UV irradiation. The tube also demonstrated a water purification capacity at a rate 2.0 times higher than a-silica tube without TiO2 impregnation. Therefore, the tubes have a great potential for developing compact and in-line VOC removal and water-purification units. OPEN ACCESSCatalysts 2015, 5 1499

We describe a sensitive plant monitoring system by the detection of the bioelectric potentials in plants with boron-doped diamond (BDD) electrodes. For sensor electrodes, we used commercially available BDD, Ag, and Pt plate electrodes. We tested this approach on a hybrid species in the genus Opuntia (potted) and three different trees (ground-planted) at different places in Japan. For the Opuntia, we artificially induced bioelectric potential changes by the surface potential using the fingers. We detected substantial changes in bioelectric potentials through all electrodes during finger touches on the surface of potted Opuntia hybrid plants, although the BDD electrodes were several times more sensitive to bioelectric potential change compared to the other electrodes. Similarly for ground-planted trees, we found that both BDD and Pt electrodes detected bioelectric potential change induced by changing environmental factors (temperature and humidity) for months without replacing/removing/changing electrodes, BDD electrodes were 5–10 times more sensitive in this detection than Pt electrodes. Given these results, we conclude that BDD electrodes on live plant tissue were able to consistently detect bioelectrical potential changes in plants.

Detecting the bio-potential changes of plants would be useful for monitoring their growth and health in the field. A sensitive plant monitoring system with flexible boron-doped diamond (BDD) electrodes prepared from BDD powder and resin (Nafion or Vylon-KE1830) was investigated. The properties of the electrodes were compared with those of small BDD plate-type electrodes by monitoring the bioelectric potentials of potted Aloe and hybrid species in the genus Opuntia. While flexible BDD electrodes have wide potential windows, their cyclic voltammograms are different from those of the BDD plate. Further, the potential gap between a pair of electrodes attached to the plants changes as the plants are stimulated artificially with a finger touch, suggesting that the bioelectric potentials in the plant also changed, manifesting as changes in the potential gap between the electrodes. The BDD electrodes were assessed for their response reproducibility to a finger stimulus for 30 days. It was concluded that the plant monitoring system worked well with flexible BDD electrodes. Further, the electrodes were stable, and as reliable as the BDD plate electrodes in this study. Thus, a flexible and inexpensive BDD electrode system was successfully fabricated for monitoring the bioelectric potential changes in plants.

No abstract