We insert two probes in the upstream and the downstream regions with respect to the electron cyclotron resonance (ECR) zone which is formed at the center of mirror fields. We measure simultaneously plasma parameters in those regions by each of them under the same operating condition. We measure ion saturation currents Iis and electron energy distribution functions at two positions. We obtain measurement results that suggest the more efficient ECR on the side closer to the microwave-launchings than those on the other side. It is consistent with the accessibility condition of the right-hand polarization wave. We also compare the charge state distributions of Ar ion beams extracted in the case of launching microwaves from the coaxial semi-dipole antenna and those from the rod antenna. We observe the higher multicharged ion beam currents at the low microwave powers in the case of the rod antenna than those in the case of the coaxial semi-dipole antenna. We also confirm stable increasements of ion beam currents at considerably high microwave powers in the case of the coaxial semi-dipole antenna. Based on the experimental results, we propose a new microwave-launching method, “dual-ECR heating” and report its preferable preliminary experimental results in this paper.

Based on experimentally obtained plasma parameters in an electron cyclotron resonance (ECR) ion source (ECRIS) and theoretical considerations, it is turned out the essential factor that is currently presumed to define the increase in multicharged ion current in ECRIS is not simply the density limit of ordinary wave and right-hand cutoffs, but is also higher density one of left-hand cutoff. There are two response guidelines that can be considered to make it possible to overcome limitations, except for the conventional simply increasing the frequency and the magnetic field strength. One is advanced high-frequency resonance, i.e., upper-hybrid resonance (UHR), which is conversion from electromagnetic to electrostatic wave essentially without cutoff. The others are due to the introduction of lower frequency waves than ECR’s one, which has no density limit in a more essential sense. The latter is the introduction of lower-hybrid resonance (LHR) or ion cyclotron resonance (ICR). We will describe experimentally obtained plasma parameters, and will discuss these candidate applications.

We have considered the accessibility condition of electromagnetic and electrostatic waves propagating in an electron cyclotron resonance (ECR) ion source (ECRIS) plasma and then investigated experimentally their correspondence relationships with production of multicharged ions. It has been clarified that there exists an efficient configuration of ECR zones for producing multicharged ion beams and has been suggested that a new resonance, i.e., upper hybrid resonance (UHR), must have occurred. We have been trying to perform advanced experiments with 4–6 GHz X-mode microwaves to the 2.45 GHz ECRIS plasma, and we have succeeded in enhancing the production of multicharged ions by launching X-mode microwaves of these bands. Furthermore, at the same time, we have observed sharp increases in electron energy distribution functions in the ECRIS plasma by means of probe methods. It has been concluded that the UHRs must have occurred when applying multiplex microwaves with their frequencies away from those frequencies for ECR in the ECRIS. In this paper, we will describe in brief the theoretical background and the results of these new experiments.

An electron cyclotron resonance (ECR) ion source (ECRIS) can generate an available amount of multicharged ions, thus it is not limited for use in the field of accelerator science, but also in medical/biological fields, such as for heavy ion beam cancer treatment and ion engines. The processes of generating multicharged ions are mainly sequential collisions of a direct ionization process by electrons, and have good ion confinement characteristics. By utilizing this confinement property, we have synthesized iron-encapsulated fullerenes, which are supramolecular and can be expected to have various high functions. Fullerenes and iron ions are vaporized from pure solid materials and introduced into the ECRIS together with the support gas. We investigated conditions under which fullerene ions do not dissociate and iron ions are generated so that both can coexist. Generated ions are extracted from the ECRIS and separated by mass/charge with a dipole magnet, and detected with a Faraday cup. This measurement system is characterized by a wide dynamic range. The charge-state distribution (CSD) of ion currents was measured to investigate the optimum conditions for supramolecular synthesis. As a result, a significant spectrum suggesting the possibility of iron-encapsulated fullerenes was obtained. This paper describes the details of these experimental results.

Electron cyclotron resonance ion sources (ECRISs) are widely applied for ion beam applications, e.g., plasma processing, cancer therapy, and ion engine of an artificial satellite. In our ECRIS, we aim at producing and extracting various ion beams from this device, in particular, Xeq+ ion beams at low energy. In the aerospace engineering field, there are problems of accumulated damages on various component materials caused by low energy of Xe ions from the engine. There are not enough experimental sputtering data for satellite materials at the Xeq+ in the low energy region. Then, we are trying to investigate the sputtering yield experimentally by irradiating the low energy Xe ion beams. To perform this experiment, it is necessary to acquire a certain amount of beam current with low energy. Then, we generate the low energy ion beams by the following steps: First, the ion beams are extracted from the ECRIS at high voltage. Next, these are transported to an ion beam irradiation system (IBIS). Finally, the ion beams are decelerated by the deceleration voltage in the IBIS. We adjusted the beamline. We measure the characteristics of the transport efficiency and decelerated ion beam currents. In this paper, we describe the experimental setup using an existing ECRIS for decelerated heavy ion beams and the results of decelerated ion beam currents.