With the increase in the power system scale, the identification of electromechanical oscillation mode parameters by traditional numerical methods can no longer meet the requirements of complete real-time analysis. Therefore, a method based on machine learning (multilayer artificial neural networks) is proposed to identify the electromechanical oscillation mode parameters of the power system. This method can take the monitorable variables of the WAMS as the input of the model and the key characteristic information such as frequency and damping ratio as the output. After processing the input and output data with randomized dynamic mode decomposition (randomized-DMD), their mapping relationship can be analyzed by using the multilayer neuron architecture. The simulation results of the 4-generator 2-area system and the IEEE 16-generator 5-area system show that this method can accurately calculate the key characteristic parameters of the system without considering the change in the control parameters and after the offline training of historical data, which shows higher accuracy, stronger robustness, and sensitive online tracking ability.

Severe disturbances in a power network can cause the system frequency to exceed the safe operating range. As the last defensive line for system emergency control, under frequency load shedding (UFLS) is an important method for preventing a wide range of frequency excursions. This paper proposes a hierarchical UFLS scheme of “centralized real-time decision-making and decentralized real-time control” for inter-connected systems. The centralized decision-layer of the scheme takes into account the importance of the load based on the equivalent transformation of kinetic energy (KE) and potential energy (PE) in the transient energy function (TEF), while the load PE is used to determine the load shedding amount (LSA) allocation in different loads after faults in real-time. At the same time, the influence of inertia loss is considered in the calculation of unbalanced power, and the decentralized control center is used to implement the one-stage UFLS process to compensate for the unbalanced power. Simulations are carried out on the modified New England 10-generator 39-bus system and 197-bus system in China to verify the performance of the proposed scheme. The results show that, compared with other LSA allocation indicators, the proposed allocation indicators can achieve better fnadir and td. At the same time, compared with other multi-stage UFLS schemes, the proposed scheme can obtain the maximum fnadir with a smaller LSA in scenarios with high renewable energy sources (RES) penetration.

Accurate and rapid estimation of electromechanical mode plays an important role in sensing the security situation of power systems. In this paper, the Compressed Dynamic Mode Decompensation (Compressed-DMD) based estimation approach was proposed to extract the electromechanical mode from high-dimensional ambient data measured by the synchrophasor measurement unit. To improve the efficiency of DMD in processing high-dimensional ambient data under the premise of ensuring calculation accuracy, the Compressed-DMD was introduced to generate the approximation of the high-dimensional left and right singular vectors by employing the aggressive random test matrices and truncated eigendecomposition. Simulation examples of IEEE 16-generator 5-area system and real measurements verify the feasibility and effectiveness of the proposed method.