The host–guest interaction as noncovalent bonds can make polymeric materials tough and flexible based on the reversibility property, which is a promising approach to extend the lifetime of polymeric materials. Supramolecular materials with cyclodextrin and adamantane are prepared by mixing host polymers and guest polymers by planetary ball milling. The toughness of the supramolecular materials prepared by ball milling is approximately 2 to 5 times higher than that of supramolecular materials prepared by casting, which is the conventional method. The materials maintain their mechanical properties during repeated ball milling treatments. They are also applicable as self‐healable bulk materials and coatings, and they retain the transparency of the substrate. Moreover, fractured pieces of the materials can be re‐adhered within 10 min. Dynamic mechanical analysis, thermal property measurements, small‐angle X‐ray scattering, and microscopy observations reveal these behaviors in detail. Scars formed on the coating disappear within a few seconds at 60 °C. At the same time, the coating shows scratch resistance due to its good mechanical properties. The ball milling method mixes the host polymer and guest polymer at the nano level to achieve the self‐healing and recycling properties.

Bulk copolymerization of alkyl acrylates and cyclodextrin (CD) host monomers produced a single movable cross-network (SC). The CD units acted as movable crosslinking points in the obtained SC elastomer. Introducing movable crosslinks into a poly(ethyl acrylate/butyl acrylate) copolymer resulted in good toughness (Gf) and stress dispersion. Here, to improve the Young’s modulus (E) and Gf of movable cross-network elastomers, the bulk copolymerization of liquid alkyl acrylate monomer swelling in SC gave another type of movable cross-network elastomer with penetrating polymers (SCPs). Moreover, the bulk copolymerization of alkyl acrylate and the CD monomer in the presence of SC resulted in dual cross-network (DC) elastomers. The Gf of the DC elastomer with a suitable weight % (wt%) of the secondary movable cross-network polymer was higher than those of the SCP or SC elastomers. The combination of suitable hydrophobicity and glass transition of the secondary network was important for improving Gf. Small-angle X-ray scattering (SAXS) indicated that the DC elastomers exhibited heterogeneity at the nanoscale. The DC elastomers showed a significantly broader relaxation time distribution than the SC and SCP elastomers. Thus, the nanoscale heterogeneity and broader relaxation time distribution were important to increase Gf. This method to fabricate SCP and DC elastomers with penetrating polymers would be applicable to improve the Gf of conventional polymeric materials.

Bulk polymerization of liquid main chain monomers in the presence of a linear polymer bearing acetylated γ-cyclodextrin (TAcγCD) (primary polymer) results in composite materials consisting of dissimilar polymer chains, hereinafter...

No abstract

No abstract