No abstract

The issue of reflector soiling becomes more important as concentrating solar thermal power plants (CSP) are being implemented at sites subject to high dust loads. In an operational power plant, a trade-off between reducing cleaning costs and cleaning related collector availability on the one hand and keeping the solar field cleanliness (ξfield) high to minimize soiling induced losses on the other hand must be found. The common yield analysis software packages system advisor model (SAM) and greenius only allow the input of a constant mean ξfield and constant cleaning costs. This oversimplifies real conditions because soiling is a highly time-dependent parameter and operators might adjust cleaning activities depending on factors such as soiling rate and irradiance. In this study, time-dependent soiling and cleaning data are used for modeling the yield of two parabolic trough plant configurations at two sites in Spain and Morocco. We apply a one-year soiling rate dataset in daily resolution measured with the tracking cleanliness sensor (TraCS). We use this as a basis to model the daily evolution of the cleanliness of each collector of a solar field resulting from the application of various cleaning strategies (CS). The thus obtained daily average ξfield is used to modify the inputs to the yield analysis software greenius. The cleaning costs for each CS are subtracted from the project's financial output parameters to accurately predict the yield of a CSP project over its lifetime. The profits obtained with different CSs are compared in a parameter variation analysis for two sites and the economically best CS is identified. The profit can be increased by more than 2.6% by the application of the best strategy relative to a reference strategy that uses a constant cleaning frequency. The error in profit calculated with constant soiling and cleaning parameters compared to the simulation with variable soiling and cleaning can be as high as 9.4%. With the presented method, temporally variable soiling rates and CS can be fully integrated to CSP yield analysis software, significantly increasing its accuracy. It can be used to determine optimum cleaning parameters.

Seeds, i.e. embryos, may be genetically different from either of their parents and moreover may express their own heterosis. The objective was to genetically analyse embryo heterosis for their own weight (i.e. seed weight) in comparison with their seedlings’ heterosis, taking the large-seeded crop (Vicia faba L.) as model. A specific diallel mating scheme was used, based on four parental lines, creating 76 seed genotypes in generations P, F1, F2 and BC. Mature seed weight was assessed for these embryo genotypes in 3 years at one German location, and young plant biomass yield of seedlings emerging from these seeds in two greenhouse experiments. The quantitative genetic analysis showed an average of 10.6% mid-parent heterosis for mature seed weight and 14.5% mid-parent heterosis for juvenile biomass. In both traits, the embryos contributed markedly and significantly via their own genes to the genetic variation. For mature embryo weight heterosis, apparently the parental difference in seed weight was decisive, whereas for juvenile biomass heterosis, genetic unrelatedness of parents had priority.

No abstract

The REELCOOP project funded by the European Union aims at developing and demonstrating three small scale solar electricity generating units with two of them using thermal power cycles and one using PV. The system described here includes parabolic trough collectors and an organic Rankine cycle (ORC), enhanced by a biogas boiler and a thermal storage. With a net aperture area of 979 m² the solar field supplies saturated steam at 170°C to the ORC which produces a nominal electrical output of 60 kW. Excess thermal energy will be stored in a novel vertical spiral plate heat exchanger with phase change material. Additionally a biogas boiler can deliver steam at the desired pressure to the ORC. Detailed planning of the hydraulic circuit is ongoing. Several components, mainly solar field and ORC, are under fabrication so that their construction on-site is expected for next winter, followed by commissioning envisaged for March 2015.