Desert dust is one of the most important atmospheric ice‐nucleating aerosol species around the globe. However, there have been very few measurements of ice‐nucleating particle (INP) concentrations in dusty air close to desert sources. In this study we report the concentration of INPs in dust laden air over the tropical Atlantic within a few days' transport of one of the world's most important atmospheric sources of desert dust, the Sahara. These measurements were performed as part of the Ice in Clouds Experiment‐Dust campaign based in Cape Verde, during August 2015. INP concentrations active in the immersion mode, determined using a droplet‐on‐filter technique, ranged from around 102 m−3 at −12°C to around 105 m−3 at −23°C. There is about 2 orders of magnitude variability in INP concentration for a particular temperature, which is determined largely by the variability in atmospheric dust loading. These measurements were made at altitudes from 30 to 3,500 m in air containing a range of dust loadings. The ice active site density (ns) for desert dust dominated aerosol derived from our measurements agrees with several laboratory‐based parameterizations for ice nucleation by desert dust within 1 to 2 orders of magnitude. The small variability in ns values determined from our measurements (within about 1 order of magnitude) is striking given that the back trajectory analysis suggests that the sources of dust were geographically diverse. This is consistent with previous work, which indicates that desert dust's ice‐nucleating activity is only weakly dependent on source.

No abstract

Abstract. Atmospheric aerosol particles are important for our planet's climate because they interact with radiation and clouds. Hence, having characterised methods to collect aerosol from aircraft for detailed offline analysis are valuable. However, collecting aerosol, particularly coarse-mode aerosol, onto substrates from a fast-moving aircraft is challenging and can result in both losses and enhancement in particles. Here we present the characterisation of an inlet system designed for collection of aerosol onto filters on board the Facility for Airborne Atmospheric Measurements (FAAM) BAe-146-301 Atmospheric Research Aircraft. We also present an offline scanning electron microscopy (SEM) technique for quantifying both the size distribution and size-resolved composition of the collected aerosol. We use this SEM technique in parallel with online underwing optical probes in order to experimentally characterise the efficiency of the inlet system. We find that the coarse-mode aerosol is sub-isokinetically enhanced, with a peak enhancement at around 10 µm up to a factor of 2 under recommended operating conditions. Calculations show that the efficiency of collection then decreases rapidly at larger sizes. In order to minimise the isokinetic enhancement of coarse-mode aerosol, we recommend sampling with total flow rates above 50 L min−1; operating the inlet with the bypass fully open helps achieve this by increasing the flow rate through the inlet nozzle. With the inlet characterised, we also present single-particle chemical information obtained from X-ray spectroscopy analysis, which allows us to group the particles into composition categories.

Experimental aerosol generation methods aim to represent natural processes; however, the complexity is not always captured and unforeseen variability may be introduced into the data. The current practices for natural and experimental aerosol generation techniques are reviewed here. Recommendations for best practice are presented, and include characterization of starting material and spray fluid, rational selection of appropriate aerosol generators, and physical and biological characterization of the output aerosol. Reporting of bioaerosol research should capture sufficient detail to aid data interpretation, reduce variation, and facilitate comparison between research laboratories. Finally, future directions and challenges in bioaerosol generation are discussed.

No abstract