More than skin deep: In spite of their identical 1:1 surface composition, the geometric and electronic structures of a multilayer and monolayer PdZn surface alloy are different, as are their catalytic selectivities. The CO2 selective multilayer alloy features surface ensembles of PdZn exhibiting a “Zn‐up/Pd‐down” corrugation (see picture). These act as “bifunctional” active sites both for water activation and for the conversion of methanol into CO2. On the monolayer alloy CO and not CO2 is produced.
Discussed are the recent experimental and theoretical results on palladium-based catalysts for selective hydrogenation of alkynes obtained by a number of collaborating groups in a joint multi-method and multi-material approach. The critical modification of catalytically active Pd surfaces by incorporation of foreign species X into the sub-surface of Pd metal was observed by in situ spectroscopy for X=H, C under hydrogenation conditions. Under certain conditions (low H2 partial pressure) alkyne fragmentation leads to formation of a PdC surface phase in the reactant gas feed. The insertion of C as a modifier species in the sub-surface increases considerably the selectivity of alkyne semi-hydrogenation over Pd-based catalysts through the decoupling of bulk hydrogen from the outmost active surface layer. DFT calculations confirm that PdC hinders the diffusion of hydridic hydrogen. Its formation is dependent on the chemical potential of carbon (reactant partial pressure) and is suppressed when the hydrogen/alkyne pressure ratio is high, which leads to rather unselective hydrogenation over in situ formed bulk PdH. The beneficial effect of the modifier species X on the selectivity, however, is also present in intermetallic compounds with X=Ga. As a great advantage, such PdxGay catalysts show extended stability under in situ conditions. Metallurgical, clean samples were used to determine the intrinsic catalytic properties of PdGa and Pd3Ga7. For high performance catalysts, supported nanostructured intermetallic compounds are more preferable and partial reduction of Ga2O3, upon heating of Pd/Ga2O3 in hydrogen, was shown to lead to formation of PdGa intermetallic compounds at moderate temperatures. In this way, Pd5Ga2 and Pd2Ga are accessible in the form of supported nanoparticles, in thin film models, and realistic powder samples, respectively
In situ FT-IR spectroscopy was exploited to study the adsorption of CO2 and CO on commercially available yttria-stabilized ZrO2 (8 mol % Y, YSZ-8), Y2O3, and ZrO2. All three oxides were pretreated at high temperatures (1173 K) in air, which leads to effective dehydroxylation of pure ZrO2. Both Y2O3 and YSZ-8 show a much higher reactivity toward CO and CO2 adsorption than ZrO2 because of more facile rehydroxylation of Y-containing phases. Several different carbonate species have been observed following CO2 adsorption on Y2O3 and YSZ-8, which are much more strongly bound on the former, due to formation of higher-coordinated polydentate carbonate species upon annealing. As the crucial factor governing the formation of carbonates, the presence of reactive (basic) surface hydroxyl groups on Y-centers was identified. Therefore, chemisorption of CO2 most likely includes insertion of the CO2 molecule into a reactive surface hydroxyl group and the subsequent formation of a bicarbonate species. Formate formation following CO adsorption has been observed on all three oxides but is less pronounced on ZrO2 due to effective dehydroxylation of the surface during high-temperature treatment. The latter generally causes suppression of the surface reactivity of ZrO2 samples regarding reactions involving CO or CO2 as reaction intermediates.
The adsorption, bonding, defect formation, and reactivity of hydrogen on different In 2 O 3 powder samples were studied by a combination of volumetric adsorption, thermal desorption, diffraction, and spectroscopic techniques. Surface reduction was observed in dry hydrogen up to 400 K, followed by reduction of surfacenear regions. Above 500 K bulk reduction, along with the formation of metallic In, sets in. Raman spectra indicate a considerable reordering of the In 2 O 3 structure in this temperature regime. Despite their TPD proven presence, the related adsorbed H-containing species were not detectable by Fourier transform infrared spectroscopy and/or Raman spectroscopy, in strong contrast to related experiments on -Ga 2 O 3 . Hydrogeninduced oxygen vacancies were found to be easily replenished by traces of water in the gas feed.
Spectroscopy of Low Temperature Plasma-Google Books Result Quantitative Molecular Spectroscopy and Gas Emissivities s penner on Amazon.com. *FREE* shipping on qualifying offers. Recent Studies on Quantitative Spectroscopy and Gas Emissivities* Quantitative molecular spectroscopy and gas emissivities in. OSA High-resolution spectroscopy of combustion gases using a. Molecular Spectroscopy: Modern Research-Google Books Result Quantitative Molecular Spectroscopy and Gas Emissivities. by S. S. Penner. See more details below. Hardcover. Item is available through our marketplace Quantitative molecular spectroscopy and gas emissivities.-eBay Quantitative molecular spectroscopy and gas emissivities.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
customersupport@researchsolutions.com
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.