In this investigation the aim is to broaden the space of optics for Low Concentrating Photovoltaic applications. The main target is to achieve the concentration of sunlight uniformly over a large photovoltaic receiver. To solve this problem we implemented a Monte-Carlo method and defined a new parameter in order to facilitate the analysis of irradiance distributions. The geometric parameters to consider in order to reach the optimization goals have been established by dichotomous search. Utilizing this numeric method, we analyzed the influence of several geometrical parameters on the behavior of hypothetical optics. With this procedure we obtained a probative configuration made of simple geometries, leading to an uniform irradiation distribution.

No abstract

No abstract

Abstract:The present study focuses on the design and choice of materials (steels S355 and 45SCD6) of a chassis of stirred tank (with a variable filling rate) for use in the manufacturing of cosmetic products. This tank or trough will be submitted to important mechanical and thermal loads and pressure according to the various manufacturing processes. The authors propose a model of thermal and mechanical loads which takes into account the operating conditions of the tank. The analysis of the first 10 modes of vibration of the frame shows that the frequencies are much higher when the filling rate is high. They are higher for steel 45SCD6 than for the S355. The simulation results show that for a selected type of steel, the equivalent Von Mises stress increases along with increase in fill rates and thermal gradient. It appears that the influence of the thermal gradient is predominant. For both steels, the Von Mises equivalent stress is maximum in the beam 32 when the thermal gradient is at its lowest stage, and in the beam 40 for the greatest thermal gradient.