On 2017 August 17 a binary neutron star coalescence candidate (later designated GW170817) with merger time 12:41:04 UTC was observed through gravitational waves by the Advanced LIGO and Advanced Virgo detectors. The Fermi Gamma-ray Burst Monitor independently detected a gamma-ray burst (GRB 170817A) with a time delay of ∼ 1.7 s with respect to the merger time. From the gravitational-wave signal, the source was initially localized to a sky region of 31 deg2 at a luminosity distance of 40 − 8 + 8 Mpc and with component masses consistent with neutron stars. The component masses were later measured to be in the range 0.86 to 2.26 M ⊙ . An extensive observing campaign was launched across the electromagnetic spectrum leading to the discovery of a bright optical transient (SSS17a, now with the IAU identification of AT 2017gfo) in NGC 4993 (at ∼ 40 Mpc ) less than 11 hours after the merger by the One-Meter, Two Hemisphere (1M2H) team using the 1 m Swope Telescope. The optical transient was independently detected by multiple teams within an hour. Subsequent observations targeted the object and its environment. Early ultraviolet observations revealed a blue transient that faded within 48 hours. Optical and infrared observations showed a redward evolution over ∼10 days. Following early non-detections, X-ray and radio emission were discovered at the transient’s position ∼ 9 and ∼ 16 days, respectively, after the merger. Both the X-ray and radio emission likely arise from a physical process that is distinct from the one that generates the UV/optical/near-infrared emission. No ultra-high-energy gamma-rays and no neutrino candidates consistent with the source were found in follow-up searches. These observations support the hypothesis that GW170817 was produced by the merger of two neutron stars in NGC 4993 followed by a short gamma-ray burst (GRB 170817A) and a kilonova/macronova powered by the radioactive decay of r-process nuclei synthesized in the ejecta.

Recent detection of gravitational waves from a neutron star (NS) merger event GW170817 and identification of an electromagnetic counterpart provide a unique opportunity to study the physical processes in NS mergers. To derive properties of ejected material from the NS merger, we perform radiative transfer simulations of kilonova, optical and near-infrared emissions powered by radioactive decays of r-process nuclei synthesized in the merger. We find that the observed near-infrared emission lasting for > 10 days is explained by 0.03 M ⊙ of ejecta containing lanthanide elements. However, the blue optical component observed at the initial phases requires an ejecta component with a relatively high electron fraction (Y e ). We show that both optical and near-infrared emissions are simultaneously reproduced by the ejecta with a medium Y e of ∼ 0.25. We suggest that a dominant component powering the emission is post-merger ejecta, which exhibits that mass ejection after the first dynamical ejection is quite efficient. Our results indicate that NS mergers synthesize a wide range of r-process elements and strengthen the hypothesis that NS mergers are the origin of r-process elements in the Universe.

The first detected gravitational wave from a neutron star merger was GW170817. In this study, we present J-GEM follow-up observations of SSS17a, an electromagnetic counterpart of GW170817. SSS17a shows a 2.5-mag decline in the z-band from 1.7 days to 7.7 days after the merger. Such a rapid decline is not comparable with supernovae light curves at any epoch. The color of SSS17a also evolves rapidly and becomes redder for later epochs; the z − H color changed by approximately 2.5 mag in the period of 0.7 days to 7.7 days. The rapid evolution of both the optical brightness and the color are consistent with the expected properties of a kilonova that is powered by the radioactive decay of newly synthesized r-process nuclei. Kilonova models with Lanthanide elements can reproduce the aforementioned observed properties well, which suggests that r-process nucleosynthesis beyond the second peak takes place in SSS17a. However, the absolute magnitude of SSS17a is brighter than the expected brightness of the kilonova models with the ejecta mass of 0.01 M ⊙ , which suggests a more intense mass ejection (∼ 0.03M ⊙ ) or possibly an additional energy source.

Transit timing analysis may be an effective method of discovering additional bodies in extrasolar systems that harbour transiting exoplanets. The deviations from the Keplerian motion, caused by mutual gravitational interactions between planets, are expected to generate transit timing variations of transiting exoplanets. In 2009, we collected nine light curves of eight transits of the exoplanet WASP‐10b. Combining these data with those published, we have found that transit timing cannot be explained by a constant period but by a periodic variation. Simplified three‐body models, which reproduce the observed variations of timing residuals, were identified by numerical simulations. We have found that the configuration with an additional planet with a mass of ∼0.1 MJ and an orbital period of ∼5.23 d, located close to the outer 5 : 3 mean motion resonance, is the most likely scenario. If the second planet is a transiter, the estimated flux drop will be ∼0.3 per cent and can be observed with a ground‐based telescope. Moreover, we present evidence that the spots on the stellar surface and the rotation of the star affect the radial‐velocity curve, giving rise to a spurious eccentricity of the orbit of the first planet. We argue that the orbit of WASP‐10b is essentially circular. Using the gyrochronology method, the host star was found to be 270 ± 80 Myr old. This young age can explain the large radius reported for WASP‐10b.

We present the Young Exoplanet Transit Initiative (YETI), in which we use several 0.2 to 2.6-m telescopes around the world to monitor continuously young (≤100 Myr), nearby (≤1 kpc) stellar clusters mainly to detect young transiting planets (and to study other variability phenomena on time-scales from minutes to years). The telescope network enables us to observe the targets continuously for several days in order not to miss any transit. The runs are typically one to two weeks long, about three runs per year per cluster in two or three subsequent years for about ten clusters. There are thousands of stars detectable in each field with several hundred known cluster members, e.g. in the first cluster observed, Tr-37, a typical cluster for the YETI survey, there are at least 469 known young stars detected in YETI data down to R = 16.5 mag with sufficient precision of 50 millimag rms (5 mmag rms down to R = 14.5 mag) to detect transits, so that we can expect at least about one young transiting object in this cluster. If we observe ∼10 similar clusters, we can expect to detect ∼10 young transiting planets with radius determinations. The precision given above is for a typical telescope of the YETI network, namely the 60/90-cm Jena telescope (similar brightness limit, namely within ±1 mag, for the others) so that planetary transits can be detected. For targets with a periodic transit-like light curve, we obtain spectroscopy to ensure that the star is young and that the transiting object can be sub-stellar; then, we obtain Adaptive Optics infrared images and spectra, to exclude other bright eclipsing stars in the (larger) optical PSF; we carry out other observations as needed to rule out other false positive scenarios; finally, we also perform spectroscopy to determine the mass of the transiting companion. For planets with mass and radius determinations, we can calculate the mean density and probe the internal structure. We aim to constrain planet formation models and their time-scales by discovering planets younger than ∼100 Myr and determining not only their orbital parameters, but also measuring their true masses and radii, which is possible so far only by the transit method. Here, we present an overview and first results.