[1] We present the first detailed 2D seismic tomographic image of the trench-outer rise, fore-and back-arc of the Tonga subduction zone. The study area is located approximately 100 km north of the collision between the Louisville hot spot track and the overriding Indo-Australian plate where ∼80 Ma old oceanic Pacific plate subducts at the Tonga Trench. In the outer rise region, the upper oceanic plate is pervasively fractured and most likely hydrated as demonstrated by extensional bending-related faults, anomalously large horst and graben structures, and a reduction of both crustal and mantle velocities. The 2D velocity model presented shows uppermost mantle velocities of ∼7.3 km/s, ∼10% lower than typical for mantle peridotite (∼30% mantle serpentinization). In the model, Tonga arc crust ranges between 7 and 20 km in thickness, and velocities are typical of arc-type igneous basement with uppermost and lowermost crustal velocities of ∼3.5 and ∼7.1 km/s, respectively. Beneath the inner trench slope, however, the presence of a low velocity zone (4.0-5.5 km/s) suggests that the outer fore-arc is probably fluid-saturated, metamorphosed and disaggregated by fracturing as a consequence of frontal and basal erosion. Tectonic erosion has, most likely, been accelerated by the subduction of the Louisville Ridge, causing crustal thinning and subsidence of the outer fore-arc. Extension in the outer fore-arc is evidenced by (1) trenchward-dipping normal faults and (2) the presence of a giant scarp (∼2 km offset and several hundred kilometers long) indicating gravitational collapse of the outermost fore-arc block. In addition, the contact between the subducting slab and the overriding arc crust is only 20 km wide, and the mantle wedge is characterized by low velocities of ∼7.5 km/s, suggesting upper mantle serpentinization or the presence of melts frozen in the mantle.Citation: Contreras-Reyes, E., I. Grevemeyer, A. B. Watts, E. R. Flueh, C. Peirce, S. Moeller, and C. Papenberg (2011), Deep seismic structure of the Tonga subduction zone: Implications for mantle hydration, tectonic erosion, and arc magmatism,

[1] Lithospheric formation at slow spreading rates is heterogeneous with multiple modalities, favoring symmetric spreading where magmatism dominates or core complex and inside corner high formation where tectonics dominate. We report microseismicity from three deployments of seismic networks at the Mid-Atlantic Ridge (MAR). Two networks surveyed the MAR near 7 S in the vicinity of the Ascension transform fault. Three inside corner high settings were investigated. However, they remained seismically largely inactive and major seismic activity occurred along the center of the median valley. In contrast, at the Logatchev Massif core complex at 14 45 0 N seismicity was sparse within the center of the median valley but concentrated along the eastern rift mountains just west of the serpentine hosted Logatchev hydrothermal vent field. To the north and south of the massif, however, seismic activity occurred along the ridge axis, emphasizing the asymmetry of seismicity at the Logatchev segment. Focal mechanisms indicated a large number of reverse faulting events occurring in the vicinity of the vent field at 3-5 km depth, which we interpret to reflect volume expansion accompanying serpentinization. At shallower depth of 2-4 km, some earthquakes in the vicinity of the vent field showed normal faulting behavior, suggesting that normal faults facilitates hydrothermal circulation feeding the vent field. Further, a second set of cross-cutting faults occurred, indicating that the surface location of the field is controlled by local fault systems.

[1] Extension of the continental lithosphere leads to the formation of rift basins and ultimately may create passive continental margins. The mechanisms that operate during the early stage of crustal extension are still intensely debated. We present the results from coincident multichannel seismic and wide-angle seismic profiles that transect across the northern Tyrrhenian Sea Basin. The profiles cross the Corsica Basin (France) to the Latium Margin (Italy) where the early-rift stage of the basin is well preserved. We found two domains, each with a distinct tectonic style, heat flow and crustal thickness. One domain is the Corsica Basin in the west that formed before the main rift phase of the northern Tyrrhenian Sea opening ($8-4 Ma). The second domain is rifted continental crust characterized by tilted blocks and half-graben structures in the central region and at the Latium Margin. These two domains are separated by a deep ($10 km) sedimentary complex of the eastern portion of the Corsica Basin. Travel-time tomography of wide-angle seismic data reveals the crustal architecture and a subhorizontal 15-17 6 1 km deep Moho discontinuity under the basin. To estimate the amount of horizontal extension we have identified the pre-, syn-, and post-tectonic sedimentary units and calculated the relative displacement of faults. We found that major faults initiated at angles of 45 -50 and that the rifted domain is horizontally stretched by a factor of $ 1.3 ($8-10 mm/a). The crust has been thinned from $24 to $17 km indicating a similar amount of extension ($30%). The transect represents one of the best imaged early rifts and implies that the formation of crustal-scale detachments, or long-lived low-angle normal faults, is not a general feature that controls the rift initiation of continental crust. Other young rift basins, like the Gulf of Corinth, the Suez Rift or Lake Baikal, display features resembling the northern Tyrrhenian Basin, suggesting that half-graben formations and distributed homogeneous crustal thinning are a common feature during rift initiation.

The Tyrrhenian Basin is a region created by Neogene extensional tectonics related to slab rollback of the east-southeast–migrating Apennine subduction system, commonly believed to be actively underthrusting the Calabrian arc. A compilation of >12,000 km of multichannel seismic profiles, much of them recently collected or reprocessed, provided closer scrutiny and the mapping of previously undetected large compressive structures along the Tyrrhenian margin. This new finding suggests that Tyrrhenian Basin extension recently ceased. The ongoing compressional reorganization of the basin indicates a change of the regional stress field in the area, confirming that slab rollback is no longer a driving mechanism for regional kinematics, now dominated by the Africa-Eurasia lithospheric collision

Extension of the continental lithosphere leads to the formation of rift basins or rifted continental margins if breakup occurs. Seismic investigations have repeatedly shown that conjugate margins have asymmetric tectonic structures and different amount of extension and crustal thinning. Here we compare two coincident wide-angle and multichannel seismic profiles across the northern Tyrrhenian rift system sampling crust that underwent different stages of extension from north to south and from the flanks to the basin center. Tomographic inversion reveals that the crust has thinned homogeneously from~24 km tõ 17 km between the Corsica Margin and the Latium Margin implying a β factor of~1.3-1.5. On the transect 80 km to the south, the crust thinned from~24 km beneath Sardinia to a maximum of~11 km in the eastern region near the Campania Margin ( β factor of~2.2). The increased crustal thinning is accompanied by a zone of reduced velocities in the upper crust that expands progressively toward the southeast. We interpret that the velocity reduction is related to rock fracturing caused by a higher degree of brittle faulting, as observed on multichannel seismic images. Locally, basalt flows are imaged intruding sediment in this zone, and heat flow values locally exceed 100 mW/m 2 . Velocities within the entire crust range 4.0-6.7 km/s, which are typical for continental rocks and indicate that significant rift-related magmatic underplating may not be present. The characteristics of the pre-tectonic, syn-tectonic and post-tectonic sedimentary units allow us to infer the spatial and temporal evolution of active rifting. In the western part of the southern transect, thick postrift sediments were deposited in half grabens that are bounded by large fault blocks. Fault spacing and block size diminish to the east as crustal thinning increases. Recent tectonic activity is expressed by faults cutting the seafloor in the east, near the mainland of Italy. The two transects show the evolution from the less extended rift in the north with a fairly symmetric conjugate structure to the asymmetric margins farther south. This structural evolution is consistent with W-E rift propagation and southward increasing extension rates.