This paper presents the results of an interlaboratory study of the rheological properties of cement paste and ultrasound gel as reference substance. The goal was to quantify the comparability and reproducibility of measurements of the Bingham parameters yield stress and plastic viscosity when measured on one specific paste composition and one particular ultrasound gel in different laboratories using

No abstract

Further innovation in the field of selective laser sintering (SLS) is strongly connected to the availability of new materials since the market is dominated by polyamide 12 (>90%). The aim of this publication is to develop a descriptive model for the droplet formation process in a Filament Extension Atomizer to predict the applicability to exploit further polymers for the SLS process. The feasibility was tested, investigated and characterized using a “Dripping out of a nozzle” setup for uniaxial extension. The droplet formation process was then observed via high-speed camera imaging and classified for certain parameters. The experiments were carried out using semi-diluted polyethylene oxide (600–4000 kg/mol), glycerol and water solutions as model fluids. Driven by the Plateau-Rayleigh instability, different types of spherical droplets were observed and various droplet formation mechanisms demonstrated and analyzed. Based on the experimental results, a predictive model is derived to describe various essential parameters.

Since suspensions (e.g., in food, cement, or cosmetics industries) tend to show wall slip, the application of structured measuring surfaces in rheometers is widespread. Usually, for parallel-plate geometries, the tip-to-tip distance is used for calculation of absolute rheological values, which implies that there is no flow behind this distance. However, several studies show that this is not true. Therefore, the measuring gap needs to be corrected by adding the effective gap extension δ to the prescribed gap height H in order to obtain absolute rheological properties. In this paper, we determine the effective gap extension δ for different structures and fluids (Newtonian, shear thinning, and model suspensions that can be adjusted to the behavior of real fluids) and compare the corrected values to reference data. We observe that for Newtonian fluids a gap- and material-independent correction function can be derived for every measuring system, which is also applicable to suspensions, but not to shear thinning fluids. Since this relation appears to be mainly dependent on the characteristics of flow behaviour, we show that the calibration of structured measuring systems is possible with Newtonian fluids and then can be transferred to suspensions up to a certain particle content.

The accessibility to rheological parameters for concrete is becoming more and more relevant. This is mainly related to the constantly emerging challenges, such as not only the development of high-strength concretes is progressing very fast but also the simulation of the flow behaviour is of high importance. The main problem, however, is that the rheological characterisation of fresh concrete is not possible via commercial rheometers. The so-called concrete rheometers provide valuable relative values for comparing different concretes, but they cannot measure absolute values. Therefore, we developed an adaptive coaxial concrete rheometer (ACCR) that allows the measurement of fresh concrete with particles up to d max = 5.5 mm {d}_{{\rm{\max }}}=5.5\hspace{.5em}{\rm{mm}} . The comparison of the ACCR with a commercial rheometer showed very good agreement for selected test materials (Newtonian fluid, shear thinning fluid, suspension, and yield stress fluid), so that self-compacting concrete was subsequently measured. Since these measurements showed a very high reproducibility, the rheological properties of the fresh concrete could be determined with high accuracy. The common flow models (Bingham (B), Herschel–Bulkley, modified Bingham (MB) models) were also tested for their applicability, with the Bingham and the modified Bingham model proving to be the best suitable ones.