The controllable incorporation of multiple immiscible elements into a single nanoparticle merits untold scientific and technological potential, yet remains a challenge using conventional synthetic techniques. We present a general route for alloying up to eight dissimilar elements into single-phase solid-solution nanoparticles, referred to as high-entropy-alloy nanoparticles (HEA-NPs), by thermally shocking precursor metal salt mixtures loaded onto carbon supports [temperature ~2000 kelvin (K), 55-millisecond duration, rate of ~10 K per second]. We synthesized a wide range of multicomponent nanoparticles with a desired chemistry (composition), size, and phase (solid solution, phase-separated) by controlling the carbothermal shock (CTS) parameters (substrate, temperature, shock duration, and heating/cooling rate). To prove utility, we synthesized quinary HEA-NPs as ammonia oxidation catalysts with ~100% conversion and >99% nitrogen oxide selectivity over prolonged operations.

All-component 3D-printed lithium-ion batteries are fabricated by printing graphene-oxide-based composite inks and solid-state gel polymer electrolyte. An entirely 3D-printed full cell features a high electrode mass loading of 18 mg cm(-2) , which is normalized to the overall area of the battery. This all-component printing can be extended to the fabrication of multidimensional/multiscale complex-structures of more energy-storage devices.

Strategy to change the wettability of the solid-state electrolyte against Li and reduce interface resistance.

All-solid-state Li-batteries using solid-state electrolytes (SSEs) offer enhanced safety over conventional Li-ion batteries with organic liquid electrolytes due to the nonflammable nature of SSEs. The superior mechanical strength of SSEs can also protect against Li dendrite penetration, which enables the use of the highest specific capacity (3861 mAh/g) and lowest redox potential (-3.04 V vs standard hydrogen electrode) anode: Li metal. However, contact between the Li metal and SSEs presents a major challenge, where a large polarization occurs at the Li metal/SSE interface. Here, the chemical properties of a promising oxide-based SSE (garnet) changed from "super-lithiophobicity" to "super-lithiophilicity" through an ultrathin coating of amorphous Si deposited by plasma-enhanced chemical vapor deposition (PECVD). The wettability transition is due to the reaction between Li and Si and the in situ formation of lithiated Si. As a result, symmetric cells composed of a Si-coated garnet-structured SSE and Li metal electrodes exhibited much smaller impedance and excellent stability upon plating/stripping cycles compared to cells using bare garnet SSE. Specifically, the interfacial resistance between Li and garnet dramatically decreased from 925 to 127 Ω cm(2) when lithiated Si was formed on the garnet. Our discovery of switchable lithiophobic-lithiophilic surfaces to improve the Li metal/SSE interface opens opportunities for improving many other SSEs.

The solar steam process, akin to the natural water cycle, is considered to be an attractive approach to address water scarcity issues globally. However, water extraction from groundwater, for example, has not been demonstrated using these existing technologies. Additionally, there are major unaddressed challenges in extracting potable water from seawater including salt accumulation and long-term evaporation stability, which warrant further investigation. Herein, a high-performance solar steam device composed entirely of natural wood is reported. The pristine, natural wood is cut along the transverse direction and the top surface is carbonized to create a unique bilayer structure. This tree-inspired design offers distinct advantages for water extraction, including rapid water transport and evaporation in the mesoporous wood, high light absorption (≈99%) within the surface carbonized open wood channels, a low thermal conductivity to avoid thermal loss, and cost effectiveness. The device also exhibits long-term stability in seawater without salt accumulation as well as high performance for underground water extraction. The tree-inspired design offers an inexpensive and scalable solar energy harvesting and steam generation technology that can provide clean water globally, especially for rural or remote areas where water is not only scarce but also limited by water extraction materials and methods.