An extensive experimental investigation was carried out to examine tip-vortex induced cavitation on a ducted propulsor. The flowfield about a 3-bladed, ducted rotor operating in uniform inflow was measured in detail with three-dimensional LDV; cavitation inception was measured; and a correlated hydrophone/high-speed video system was used to identify and characterize the early, sub-visual cavitation events. Two geometrically-similar, ducted rotors were tested over a Reynolds number range from 1.4×106 to 9×106 in order to determine how the tip-vortex cavitation scales with Reynolds number. Analysis of the data shows that exponent for scaling tip-vortex cavitation with Reynolds number is smaller than for open rotors. It is shown that the parameters which are commonly accepted to control tip-vortex cavitation, vortex circulation and vortex core size, do not directly control cavitation inception on this ducted rotor. Rather it appears that cavitation is initiated by the stretching and deformation of secondary vortical structures resulting from the merger of the leakage and tip vortices.

Experiments are described in which the pressure distribution on two model controllable-pitch propellers was measured. The pressure was measured at 40 locations on the blade surface with the propeller operating in both uniform and inclined flow. The discussion of the experimental technique includes a description of the hardware and data analysis systems.

Public reporting burden for this collection of information Is estimated to average 1 hour per response, including the time for reviewing Instructions, searching existing data sources, gathering and maintaining the data needed, and completing and reviewing the collection of information Send comments regarding this burden estimate or any other aspect of this collection of information, including suggestions for reducing this burden to Washington Headquarters Services, Directorate for information. Operations and Reports,

Directorate Report, CRDKNSWC/HD-1460-02, "Cavitation and 3-D LDV Tip-Flowfield Measurements of Propeller 5168 by Christopher J. Chesnakas and Stuart Jessup (May 1998) (2) Customer Project Survey Form 5200-20A (Rev 4) 1. Enclosure (1) is forwarded for your information and retention. 2. It is requested that enclosure (2) be completed and returned to the Carderock Division, Naval Surface Warfare Center. Customer project surveys are conducted at the completion of a project. They are used at the Department level to control and verify the system process capability. The forms will be reviewed for customer comments, including complaints and recommendations. Corrective actions will be taken.

Tip vortices generated by marine lifting surfaces such as propeller blades, ship rudders, hydrofoil wings, and antiroll fins can lead to cavitation. Prediction of the onset of this cavitation depends on model tests at Reynolds numbers much lower than those for the corresponding full-scale flows. The effect of Reynolds number variations on the scaling of tip vortex cavitation inception is investigated using a theoretical flow similarity approach. The ratio of the circulations in the full-scale and model-scale trailing vortices is obtained by assuming that the spanwise distributions of the section lift coefficients are the same between the model-scale and the full-scale. The vortex pressure distributions and core sizes are derived using the Rankine vortex model and McCormick’s assumption about the dependence of the vortex core size on the boundary layer thickness at the tip region. Using a logarithmic law to describe the velocity profile in the boundary layer over a large range of Reynolds number, the boundary layer thickness becomes dependent on the Reynolds number to a varying power. In deriving the scaling of the cavitation inception index as the ratio of Reynolds numbers to an exponent m, the values of m are not constant and are dependent on the values of the model- and full-scale Reynolds numbers themselves. This contrasts traditional scaling for which m is treated as a fixed value that is independent of Reynolds numbers. At very high Reynolds numbers, the present theory predicts the value of m to approach zero, consistent with the trend of these flows to become inviscid. Comparison of the present theory with available experimental data shows promising results, especially with recent results from high Reynolds number tests. Numerical examples of the values of m are given for different model- to full-scale sizes and Reynolds numbers.