In the basic oxygen steelmaking (BOS) process, fast dissolution of lime in slag would promote quick formation of a suitable slag, which could increase the process productivity and improve the steel quality at reduced cost. Many studies have been carried out to investigate the dissolution of lime in slag in terms of the mechanism, dissolution rate and influencing factors under well controlled experimental conditions. In this study, the dissolution of lime in BOS slag was studied by characterising the lime particle and its surrounding area in the slag samples taken from a laboratory induction furnace during hot metal dephosphorisation experiment, a 6 t pilot plant converter and a 320 t industrial converter. The mechanism of lime dissolution in BOS slag is discussed under varying dynamic conditions from laboratory experiment to industrial converter.

A thermodynamic (equilibrium) model is developed for the BOF process. The predictions of this model show the trend of reactions when the process is considered to be at thermodynamic equilibrium. In the case of a real process, however, some tuning and adaptation becomes necessary to make more accurate predictions. A dynamic model is developed in which the kinetics of scrap dissolution is also incorporated. A comparison of the results of the equilibrium and dynamic models (made with some tuning parameters) reveals that mixing is the prime factor which can alter the course of reaction at any particular instant. Mixing is greatly affected by oxygen flow rate, lance height and the nature of scrap. The understanding of the secrets of process dynamics becomes clearer with this approach, providing a good insight into the process.

Excess slag foam growth is a frequent problem in the BOS process. In the worst case, foam is forced out of the vessel and this phenomenon, commonly called slopping, not only results in loss of valuable metal yield but also in equipment damage and lost production time. In order to minimize slopping, accurate estimation of the foam level inside the vessel is an important part of BOS process control. In the top blown BOS vessel, slopping control is achieved using both static and dynamic measures. The most common implemented technique for dynamic foam height estimation and slopping control is the audiometer system. An alternative method, vessel vibration monitoring, has been investigated as part of the work in a RFCS funded research project called IMPHOS. In order to judge the usefulness of this method, parallel vibration and audio measurements have been carried out on 130 tonne as well as on 300 tonne BOS vessels. The results show that during stable process conditions there is good agreement between the two methods with regard to foam height estimation and, as vessel vibration and audiometry are largely independent of each other, a combination of the two is likely to increase significantly the accuracy of slopping prediction.

No abstract