A survey of disinfection byproduct (DBP) occurrence in the United States was conducted at 12 drinking water treatment plants. In addition to currently regulated DBPs, more than 50 DBPs that rated a high priority for potential toxicity were studied. These priority DBPs included iodinated trihalomethanes (THMs), other halomethanes, a nonregulated haloacid, haloacetonitriles, haloketones, halonitromethanes, haloaldehydes, halogenated furanones, haloamides, and nonhalogenated carbonyls. The purpose of this study was to obtain quantitative occurrence information for new DBPs (beyond those currently regulated and/or studied) for prioritizing future health effects studies. An effort was made to select plants treating water that was high in total organic carbon and/or bromide to enable the detection of priority DBPs that contained bromine and/or iodine. THMs and haloacetic acids (HAAs) represented the two major classes of halogenated DBPs formed on a weight basis. Haloacetaldehydes represented the third major class formed in many of the waters. In addition to obtaining quantitative occurrence data, important new information was discovered or confirmed at full-scale plants on the formation and control of DBPs with alternative disinfectants to chlorine. Although the use of alternative disinfectants (ozone, chlorine dioxide, and chloramines) minimized the formation of the four regulated THMs, trihalogenated HAAs, and total organic halogen (TOX), several priority DBPs were formed at higher levels with the alternative disinfectants as compared with chlorine. For example, the highest levels of iodinated THMs-which are not part of the four regulated THMs-were found at a plant that used chloramination with no prechlorination. The highest concentration of dichloroacetaldehyde was at a plant that used chloramines and ozone; however, this disinfection scheme reduced the formation of trichloroacetaldehyde. Preozonation was found to increase the formation of trihalonitromethanes. In addition to the chlorinated furanones that have been measured previously, brominated furanones-which have seldom been analyzed-were detected, especially in high-bromide waters. The presence of bromide resulted in a shift to the formation of other bromine-containing DBPs not normally measured (e.g., brominated ketones, acetaldehydes, nitromethanes, acetamides). Collectively, -30 and 39% of the TOX and total organic bromine, respectively, were accounted for (on a median basis) bythe sum of the measured halogenated DBPs. In addition, 28 new, previously unidentified DBPs were detected. These included brominated and iodinated haloacids, a brominated ketone, and chlorinated and iodinated aldehydes.
Data were gathered on the presence of disinfection by-products (DBPs) in drinking water and picrin (CHP); chloral hydrate (CH); on the impact of treatment processes on DBP formation and control. Thirty-five water cyanogen chloride (CNCI); 2,4,6-trichlotreatment facilities were selected to provide a broad range of source water qualities and rophenol; formaldehyde; and acetaldetreatment processes. Trihalomethanes were the largest class of DBPs detected (on a weight hyde (Figure 1). This article focuses on basis) in this study, with haloacetic acids being the next most significant DBP fraction. some of the significant preliminary Formaldehyde and acetaldehyde, by-products of ozonation, were also demonstrated to be findings of these DBP studies. produced by chlorination. Cyanogen chloride was found to be preferentially produced in Experimental procedures chloraminaied water.The sampling and analytical proceof this project, baseline data were gath-dures utilized in these studies are deered on all 35 water utilities.
Effluents from wastewater treatment plants (WWTPs) contain disinfection byproducts (DBPs) of health concern when the water is utilized downstream as a potable water supply. The pattern of DBP formation was strongly affected by whether or not the WWTP achieved good nitrification. Chlorine addition to poorly nitrified effluents formed low levels of halogenated DBPs, except for (in some cases) dihalogenated acetic acids, but often substantial amounts of N-nitrosodimethyamine (NDMA). Chlorination of well-nitrified effluent typically resulted in substantial formation of halogenated DBPs but much less NDMA. For example, on a median basis after chlorine addition, the well-nitrified effluents had 57 microg/L of trihalomethanes [THMs] and 3 ng/L of NDMA, while the poorly nitrified effluents had 2 microg/L of THMs and 11 ng/L of NDMA. DBPs with amino acid precursors (haloacetonitriles, haloacetaldehydes) formed at substantial levels after chlorination of well-nitrified effluent. The formation of halogenated DBPs but not that of NDMA correlated with the formation of THMs in WWTP effluents disinfected with free chlorine. However, THM formation did not correlate with the formation of other DBPs in effluents disinfected with chloramines. Because of the relatively high levels of bromide in treated wastewater, bromine incorporation was observed in various classes of DBPs.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
customersupport@researchsolutions.com
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.