Recent experimental and theoretical studies have shown that the thermal to electrical power conversion efficiency (as measured by the thermoelectric figure of merit) can be enhanced in nanocomposite materials. Primarily, these efforts to improve the thermoelectric efficiency rely on reducing the lattice thermal conductivity through nanostructuring of the materials or the introduction of a second nanometer-scale phase into the composite material. Here, we show that the inclusion of semimetal nanoparticles into bismuth telluride (Bi 2 Te 3 ) can result in both an increase in the electronic transport properties (so called "power factor") as well as a decrease in lattice thermal conductivity. The effect of different volume fractions of Bi nanoinclusions (3% and 5%) on the thermal and electrical properties of the composite are reported. A marginal increase in the thermoelectric figure of merit is achieved for 3% metal nanoinclusion, whereas a significant improvement in the figure of merit could be achieved for 5% nanoinclusions in the Bi 2 Te 3 thermoelectric matrix.

The carrier concentration and electronic transport properties in Bi 2-x Sb x Te 3 alloy can be tuned by varying the Bi to Sb ratio, for high thermoelectric figure of merit. The concentration of intrinsic antisite defects in these alloys is also known to change with Bi to Sb ratio. Here we report the thermoelectric figure of merit of Sn doped Bi 0.5 Sb 1.5 Te 3 alloy. Different atomic percentages of Sn was substituted at Bi/Sb site in Bi 0.5 Sb 1.5 Te 3 alloy, synthesized by planetary ball milling. The electrical conductivity decreases with increasing Sn doping but for higher Sn content the electrical conductivity increases compared to undoped alloy. The Seebeck coefficient changes in accordance to electrical conductivity, resulting in small decrease in power factor for highest Sn doping. The lattice thermal conductivity shows a systematic decrease, with increasing Sn concentration resulting in a significant thermal conductivity reduction. Hence an increase in thermoelectric figure of merit could be achieved for the highest Sn (3at%) doping in Bi 0.5 Sb 1.5 Te 3 alloy as compared to undoped alloy.

Metal nanoinclusions inside the bulk thermoelectric matrix have the potential to increase the power factor and reduce the lattice thermal conductivity. We have synthesized Bi 2-x Te 3+x (x=0, 0.5)compositions, to achieve better tenability in Seebeck and electrical conductivity. In this matrix phase, different volume fractions of Bi metal nanoinclusions were incorporated and its effect on thermoelectric properties is discussed. Ag metal nanoinclusions were incorporated into Bi 2 Te 3 (2:3) composition, and its effect on power factor is discussed here.