Phase-change materials undergo rapid and reversible crystalline-to-amorphous structural transformation and are being used for nonvolatile memory devices. However, the transformation mechanism remains poorly understood. We have studied the effect of electrical pulses on the crystalline-to-amorphous phase change in a single-crystalline Ge(2)Sb(2)Te(5) (GST) nanowire memory device by in situ transmission electron microscopy. We show that electrical pulses produce dislocations in crystalline GST, which become mobile and glide in the direction of hole-carrier motion. The continuous increase in the density of dislocations moving unidirectionally in the material leads to dislocation jamming, which eventually induces the crystalline-to-amorphous phase change with a sharp interface spanning the entire nanowire cross section. The dislocation-templated amorphization explains the large on/off resistance ratio of the device.

The authors, demonstrated that 4.5-nm-half-pitch structures could be achieved using electron-beam lithography, followed by salty development. They also hypothesized a development mechanism for hydrogen silsesquioxane, wherein screening of the resist surface charge is crucial in achieving a high initial development rate, which might be a more accurate assessment of developer performance than developer contrast. Finally, they showed that with a high-development-rate process, a short duration development of 15 s was sufficient to resolve high-resolution structures in 15-nm-thick resist, while a longer development degraded the quality of the structures with no improvement in the resolution.

We introduce a method to fabricate solid-state nanopores with sub-20 nm diameter in membranes with embedded metal electrodes across a 200 mm wafer using CMOS compatible semiconductor processes. Multi-layer (metal-dielectric) structures embedded in membranes were demonstrated to have high uniformity (± 0.5 nm) across the wafer. Arrays of nanopores were fabricated with an average size of 18 ± 2 nm in diameter using a Reactive Ion Etching (RIE) method in lieu of TEM drilling. Shorts between the membrane-embedded metals were occasionally created after pore formation, but the RIE based pores had a much better yield (99%) of unshorted electrodes compared to TEM drilled pores (<10%). A double-stranded DNA of length 1 kbp was translocated through the multi-layer structure RIE-based nanopore demonstrating that the pores were open. The ionic current through the pore can be modulated with a gain of 3 using embedded electrodes functioning as a gate in 0.1 mM KCl aqueous solution. This fabrication approach can potentially pave the way to manufacturable nanopore arrays with the ability to electrically control the movement of single or double-stranded DNA inside the pore with embedded electrodes.

By introducing ZnS between Cu(In, Ga)(S,Se) 2 (CIGS) and the CdS, we greatly improved the photoelectrochemical (PEC) performance of the CIGS photocathode for hydrogen evolution. Chemical and structural analysis reveals that the enhanced performance is due to additional band bending driven by in-diffusion of Zn into the CIGS and suppression of nonradiative recombination. The improved onset potential of CIGS photocathode was exploited by building a tandem device with a perovskite absorber for bias-free water splitting. A PEC device with a solar-to-hydrogen conversion efficiency exceeding 9% (the highest among PEC cells including a CIGS photocathode) with a stable operation of 6.5 h is demonstrated.