This work reports on the influence of the polarization of electroactive poly(vinylidene fluoride), PVDF, on the biological response of cells cultivated under static and dynamic conditions. Non-poled and ''poled +'' b-PVDF with and without a titanium layer were thus prepared. A thin titanium layer was deposited on PVDF films in order to obtain a more homogeneous surface charge. The MC3T3-E1 osteoblast cell culture exhibited different responses in the presence of PVDF films. The positively charged b-PVDF films promote higher osteoblast adhesion and proliferation, which is higher under dynamic conditions on poled samples, showing that the surface charge under mechanical stimulation improves the osteoblast growth. Therefore, electroactive membranes and scaffolds can provide the necessary electrical stimuli for the growth and proliferation of specific cells.

The incorporation of graphene-based materials has been shown to improve mechanical properties of poly(lactic acid) (PLA). In this work, PLA films and composite PLA films incorporating two graphene-based materials - graphene oxide (GO) and graphene nanoplatelets (GNP) - were prepared and characterized regarding not only biocompatibility, but also surface topography, chemistry and wettability. The presence of both fillers changed the films surface topography, increasing the roughness, and modified the wettability - the polar component of surface free energy increased 59% with GO and decreased 56% with GNP. Mouse embryo fibroblasts incubated with both fillers exceeded the IC(50) in both cases with a concentration of 10 μg mL(-1). No variations in cell proliferation at the surface of the composite films were observed, except for those containing GO after 24 h incubation, which presented higher cell proliferation than pristine PLA films. Platelet adhesion to PLA and PLA/GNP films was lower in the presence of plasma proteins than when no proteins were present. Furthermore, incorporation of GNP into PLA reduced platelet activation in the presence of plasma proteins. The results indicated that low concentrations of GO and GNP may be incorporated safely in PLA to improve aspects relevant for biomedical applications, such as mechanical properties.

Nanomaterials have unusual properties not found in the bulk materials, which can be exploited in numerous applications such as biosensing, electronics, scaffolds for tissue engineering, diagnostics and drug delivery. However, research in the past few years has turned up a range of potential health hazards, which has given birth to the new discipline of nanotoxicology. Bacterial cellulose (BC) is a promising material for biomedical applications, namely due its biocompatibility. Although BC has been shown not to be cytotoxic or genotoxic, the properties of isolated BC nanofibres (NFs) on cells and tissues has never been analysed. Considering the toxicity associated to other fibre-shaped nanoparticles, it seems crucial to evaluate the toxicity associated to the BC-NFs. In this work, nanofibres were produced from bacterial cellulose by a combination of acid and ultrasonic treatment. The genotoxicity of nanofibres from bacterial cellulose was analysed in vitro, using techniques previously demonstrated to detect the genotoxicity of fibrous nanoparticles. The results from single cell gel electrophoresis (also known as comet assay) and the Salmonella reversion assays showed that NFs are not genotoxicity under the conditions tested. A proliferation assay using fibroblasts and CHO cells reveals a slight reduction in the proliferation rate, although no modification in the cell morphology is observed.