Although pre-fabricated carbon fibre posts have been used during the past decade clinical evaluations of the technique are still few. Using dental records and radiographs the clinical performance of 65 pre-fabricated carbon fibre posts (Composipost and Endopost) placed in 48 patients who regularly visited a general practice were evaluated in the present study. After an average time of 2.3 +/- 0.8 years (median 2.1 years, range 1-4.9 years) of clinical service the failure rate was 3%. Failure occurred in one tooth with a single crown restoration and in one tooth that was part of a cantilever fixed partial denture. Although the failure rate is lower than those mostly reported for metallic posts and cores more clinical studies are necessary to assess the suitability of pre-fabricated carbon fibre posts for routine use as an alternative to individually cast posts.

No abstract

The effect of ultrasonic insertion on the filler content and the gap width for two brands of composite resin luting agents, intended for luting with the ultrasonic insertion technique, were studied after MOD ceramic inlays (Cerec) had been placed. In addition, the internal and marginal gap widths were determined after MOD ceramic inlays (Celay) bad been luted on extracted premolars with this technique. No statistically significant differences (P > 0.05) were observed for either brand between the filler content obtained from the internal surfaces, from the excess luting agent, or from the luting agent as delivered. There were no statistically significant differences (P > 0.05) between the final internal and marginal gap widths when the two brands of luting agent were compared with each other. Except for the final occlusal and internal gap widths obtained for the inlays luted with the Sono-Cem luting agent, no statistically significant differences (P > 0.05) were observed between the gap widths at the different locations determined. Thus, the ultrasonic insertion technique used did not significantly influence the filler ratio of the hybrid luting agents studied. Judged by the findings in this study, the properties of luting agents seem to greatly influence the final marginal and internal gap widths.