The lightweight floor system (LFS) with a heating coil is one of many types of radiant heating systems. It differs from most of the others, as it has a much higher thermal efficiency at low flow temperature. To verify whether adhesive mortars can safely connect the ceramic floor with the insulating substrate, the deformations and stresses values of all light system layers under thermal action should be checked and compared to their maximum strengths. For this purpose, an LFS test field was conducted using the strain gauges and digital measurement techniques, and floor displacements and deformations were determined. The results obtained from the tests were confirmed by finite element method calculations. It was also found that the stress of each floor component was much lower than their strength. This proves that the LFS with a heating coil, without metal lamellas, meets the safety regulation for use. The results of the analysis can be useful in the design of heated/cooled LFSs.
AbstractThe article presents the results of shear and tensile strength of deformable cement adhesives, reinforced by fiberglass mesh with a different weight in a lightweight floor system without screeds. The substrate under adhesive was EPS and XPS thermal insulation. Tests were carried out in dry, wet conditions as well as during freezing and thawing. On their basis, it can be concluded that the larger contact surface of the EPS thermal insulation with the deformable adhesive C2S1 increases the adhesive’s tensile strength. This surface is not important using C2S2 adhesives or when the substrate is made from rough insulation XPS. It was generally found that the higher weight of the fibreglass mesh in deformable cement adhesives has a more favorable effect on their shear strength. Water absorption does not significantly affect the adhesion of terracotta, and in some configurations of components in this system increases it. The adhesive with the symbol C2S2 compared to C2S1 has a higher tensile and shear strength using the same materials. Frost conditions do not allow for long-term use of this type of floor construction in snow and ice protection systems. This experimental research shows that an economical solution with optimal strength consists of XPS insulation, 205 g/m2 mesh, C2S1 adhesive.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.