No abstract

No abstract

In this work, the flank wear of the cutting tool is predicted using artificial neural network based on the responses of cutting force and surface roughness. EN8 steel is chosen as a work piece material and turning test is conducted with various levels of speed, feed and depth of cut. Cutting force and surface roughness are measured for both the fresh and dull tool under dry cutting conditions. The tool insert used is CNMG 120408 grade, TiN coated cemented carbide tool. The experiments are conducted based on the response surface methodology face central composite design of experiments. The feed rate (14.52%), depth of cut (27.72%) and the interaction of feed rate and depth of cut (50.39%) influence the cutting force. The feed rate (21.33%) and the interaction of cutting speed and depth of cut (26.67%) influence the flank wear. The feed rate (61.63%) has the significant influence on surface roughness. The feed forward back propagation neural network of 5-n-1 architecture is trained using the algorithms like Levenberg Marquardt, BFGS quasi-Newton, and Gradient Descent with Momentum and Gradient descent with adaptive learning rate. The network performance has been assessed based on their mean square error and computation time. From this analysis, the BFGS quasi-Newton back propagation algorithm produced the least mean squared error value with minimum computation time.

In this work, a milling dynamometer based on strain gauge with an octagonal and square ring was designed and tested. Strain gauges were attached with the mechanical rings to detect the deformation, during the machining process. Wheatstone bridge circuit was equipped with gauges to acquire the strain as voltage owing to the deformation of mechanical rings when machining takes place. The finite element analysis (FEA) was used to identify the location of maximum deformation and stress. The direction of rings and location of gauges were decided to increase the sensitivity and decrease the cross-sensitivity. Then, the cutting force was acquired through NI 6221 M series data acquisition (DAQ) card. The dynamometer had undergone a cycle of tests to verify its static and dynamic characteristics. The metrological characterization was performed according to the calibration procedure based on ISO 376 – 2011 standard. The cutting force was measured with both the dynamometers through milling experiments based on Taguchi’s L9 orthogonal array and the results were recorded. The measured cutting force varied from 300 N to 550 N. The obtained results depicted that low-cost milling dynamometer was reliable to measure the three component machining force. Overall, the square ring based dynamometer provides the better static and dynamic characteristics in terms of linearity, cross-sensitivity (4%), uncertainty (0.054%), and natural frequency (362.41 rev/s).

No abstract