This paper deals with implementation of Sinusoidal Pulse-Width-Modulation (SPWM) for a single-phase hybrid power filter generator for Photovoltaic (PV) and wind grid applications. Using policy iteration algorithm, an improved variable step-size perturbation and observation algorithm is contrived and it is implemented proficiently using a hardware description language (VHDL) (Very High Speed Integrated Circuit Hardware Description Language). Subsequently, the new generated grid source supplements the existing grid power in rural houses during its cut off or restricted supply period. The software is used for generating SPWM modulation integrated with a solar-power & wind power grid system which is implemented on the Spartan 3 FPGA. The proposed algorithm performs as a conventional controller in terms of tracking speed and mitigating fluctuation output power in steady state operation which is shown in the experimental results with a commercial PV array and HPW (Height Weight Proportional) show. Simulation results demonstrate the validity with load of the proposed algorithm.

The development of non-linear loads at consumers has significantly impacted power supply systems. Since, the poor power quality has been found in the three-phase distribution system due to unbalanced loads, harmonic current, undesired voltage regulation, and extreme reactive power demand. To overcome this issue, Distributed STATicCOMpensator (DSTATCOM) is implemented. DSTATCOM is a shunt-connected Voltage Source Converter (VSC) that has been utilized in distribution networks to balance the bus voltage in terms of enhancing reactive power control and power factor. DSTATCOM can provide both rapid and continuous capacitive and inductive mode compensation. A rectified resistive and inductive load eliminates current harmonics in a three-phase power supply. The synchronous fundamental DQ frame is a time-domain approach developed from three-phase system space vector transformations has been designed using MATLAB/Simulink. The DQ theory is used to produce the reference signal for the Pulse Width Modulation (PWM) generator. In addition, a traditional Proportional Integral Derivative (PID) controller is designed and compared with proposed soft computing approaches such as Fuzzy-PID and Artificial Neural Network (ANN-PID) and compared accurate reference current determination for Direct Current (DC) bus through DC link. An Analytical explores the proposed control strategies given to establish superior outcomes. Finally, total harmonic distortion analysis should be taken for performance analysis of the proposed system with IEEE standards.

This paper presents the performance of PV-based embedded dual power source of SL quasi Z source inverter. The SL quasi Z source inverter with an embedded PV source and a dual power source (DPS) is injected into the system. The DPS helps the system to operate at an equilibrium state and stabilizes the entire system during PV power fluctuations. The design of the proposed system is carried out in MATLAB/Simulink environment. The control strategy with the PI controller is adopted. ESLQ Z source inverter with voltage boost method is employed with basic SPWM methodology will be suitable for IM drive applications. The system has the merit of a low inrush current that will protect and increase the life of switching devices. Finally, the study and simulation setup is validated by proving their good operating features. The proposed work is trustworthy that minimizes the total distortion factor, start-up inrush current with improved performance. Keywords: Photo voltaic (PV), embedded dual power SL quasi Z source inverter, Induction motor drive (IM), PI controller.