Hydrogen production via solar water splitting can be enhanced by combining semiconductors with various 2-dimensional materials.

BiVO(4) semiconductor electrodes were coupled with cobalt-phosphate complexes (CoPi) to enhance the photoelectrochemical (PEC) performance for water oxidation reaction. CoPi was deposited on a 550 nm-thick BiVO(4) film via electrodeposition (ED) and photodeposition (PD) methods for comparison of their effects. The CoPi on BiVO(4) exhibited Co : P atomic ratios of approximately 1 : 7 for the electrodeposited sample and approximately 1 : 18 for the photodeposited sample, and Co(2+) and Co(3+) co-existed in both samples. Optimized CoPi ED resulted in a CoPi overlayer of approximately 850 nm thick, which showed an electrochromic-like behavior that was likely due to limited access of phosphate into BiVO(4) across the CoPi layer. Optimized CoPi PD, however, had very thin and rather uniform CoPi dispersion and did not show electrochromic-like behavior. Despite the lesser amount of CoPi, the PEC performance of BiVO(4)/CoPi (PD) was comparable to that of BiVO(4)/CoPi (ED). Real-time measurements of the headspace molecular oxygen that evolved from water oxidation indicated that CoPi enhances O(2) production and photocurrent generation at BiVO(4) by a factor of around 15 and a maximum of 20, respectively, at 0.576 V(SCE) (equivalent to 1.23 V(RHE)) under air mass 1.5 irradiation (400 mW cm(-2)). Prolonged irradiation of BiVO(4)/CoPi (ED) resulted in a reduced Co : P ratio to 1 : 1.77 without changing the mixed valency of Co(II/III). This finding indicates that incorporation of phosphate into the CoPi was kinetically slower than water oxidation. The primary role of CoPi has been suggested as a hole-conducting electrocatalyst making the photogenerated electrons more mobile and, consequently, increasing conductivity and boosting the PEC water oxidation performance of BiVO(4).

To improve the photoelectrochemical (PEC) performance of BiVO4, three different modifications (doping, heterojunction, and catalyst deposition) using earth-abundant elements are performed and their effects are compared in a 0.1 M phosphate electrolyte at pH 7 under AM1.5 light (100 mW/cm2). When a hexavalent element (Cr6+, W6+, or Mo6+) is doped at various levels, the Mo6+-doping effect is most significant at 10 atomic % with about two times higher photocurrent generation at the oxygen evolution potential (1.23 VRHE). Such enhancement is attributed to a decrease in charge transfer resistance (R ct) by donor doping, resulting in an approximate 2-fold increase in charge separation efficiency (ηsep) to about 25%. W6+ is less effective than Mo6+, whereas Cr6+ has a detrimental effect. To further improve the charge separation efficiency of Mo6+-doped BiVO4 (Mo-BiVO4), a approximate 600 nm thick WO3 layer is deposited under a similarly thick Mo-BiVO4 layer. This binary heterojunction (WO3/Mo-BiVO4) exhibits ηsep of about 50% along with more than 3 times higher photocurrent generation. On the other hand, an oxygen evolving cobalt-phosphate (Co-Pi) catalyst electrodeposited to Mo-BiVO4 (Mo-BiVO4/Co-Pi) enhances charge injection efficiency (ηinj) from ∼50 to ∼70% at 1.23 V RHE. These two binaries are coupled into a ternary heterojunction (WO3/Mo-BiVO4/Co-Pi) in order to improve the charge transfer efficiencies (ηsep and ηinj). The PEC performance of this ternary is significantly high with photocurrent density of about 2.4 mA/cm2 at 1.23 VRHE (corresponding to the solar-to-hydrogen efficiency of ca. 3%) due to ηsep and ηinj of ∼60 and 90%, respectively.

No abstract