This paper reports the improvement of a bitterness sensor based on a lipid polymer membrane consisting of phosphoric acid di-n-decyl ester (PADE) as a lipid and bis(1-butylpentyl) adipate (BBPA) and tributyl o-acetylcitrate (TBAC) as plasticizers. Although the commercialized bitterness sensor (BT0) has high sensitivity and selectivity to the bitterness of medicines, the sensor response gradually decreases to almost zero after two years at room temperature and humidity in a laboratory. To reveal the reason for the deterioration of the response, we investigated sensor membranes by measuring the membrane potential, contact angle, and adsorption amount, as well as by performing gas chromatography-mass spectrometry (GC-MS), liquid chromatography-tandem mass spectrometry (LC-MS/MS). We found that the change in the surface charge density caused by the hydrolysis of TBAC led to the deterioration of the response. The acidic environment generated by PADE promoted TBAC hydrolysis. Finally, we succeeded in fabricating a new membrane for sensing the bitterness of medicines with higher durability and sensitivity by adjusting the proportions of the lipid and plasticizers.

Technologies for quantifying bitterness are essential for classifying medicines. As previously reported, taste sensors with lipid polymer membranes can respond to bitter hydrochloride substances in pharmaceuticals. However, the acid hydrolysis reaction between the lipid phosphoric acid di-n-decyl ester (PADE) and the plasticizer tributyl o-acetylcitrate (TDAB) led to a deterioration in sensor responses during storage. Given the cost of transportation and preservation for commercialization, membrane components that maintain physical and chemical stability during long-term storage are needed. Here we present a membrane electrode based on hydrophobic tetrakis [3,5-bis (trifluoromethyl) phenyl] borate (TFPB) and a plasticizer 2-nitrophenyl octyl ether (NPOE) for the quantification of pharmaceutical bitterness; they maintain a stable response before and after accelerated deterioration, as well as high selectivity and sensitivity. It is a first attempt to use a completely dissociative substance to replace non-completely dissociative lipids. Our work offsets the long-term stability issue of a bitterness sensor with a negatively charged hydrophobic membrane. Meanwhile, we provide the opportunity to select surface charge modifiers for a membrane surface using ester plasticizers containing oppositely charged impurities.