To determine the role of vasoactive peptides such as endothelin (ET), calcitonin gene-related peptide (CGRP) and human atrial natriuretic peptide (hANP) in the regulation of blood pressure in uremic patients, and to determine the effect of various types of dialyzer membranes on hemodialysis (HD)-induced changes in plasma levels of such peptides, plasma ET, CGRP and hANP were measured in HD patients and patients on continuous ambulatory peritoneal dialysis (CAPD). Plasma levels of ET, CGRP, and hANP were significantly higher in HD and CAPD patients than in healthy subjects. There were no significant differences in plasma levels of ET, CGRP, and hANP between hypertensive and normotensive HD patients, and no significant correlation was observed between HD-induced changes in plasma levels and changes in blood pressure. Plasma levels of ET decreased when HD was performed using high-flux membranes, such as polyacrylonitrile (PAN), polymethyl methacrylate (PMMA) and cellulose triacetate (CTA), but did not decrease using a saponified cellulose (SC) membrane. Plasma levels of CGRP decreased in the case of PAN, but increased significantly with PMMA and showed no change with SC and CTA. Plasma levels of hANP decreased in all types of dialyzer membranes due to decreased secretion. These results indicate that the effect of HD on plasma levels of ET and CGRP, but not hANP, depends on the type of dialyzer membrane used.
The effects of degree of cross-links on the adhesion properties of polydimethylsiloxane (PDMS) were investigated with the use of a point-contact method in air at room temperature. The degree of cross-links, rho, was varied in a wide range, inducing changes in the rheology of the cross-linked PDMS from viscous solution to elastic gel, and the adhesion properties were examined by changing the separation velocity under a constant normal load and waiting period prior to separation. As a result, the adhesion force, F(A), strongly depended on rho and showed a maximum at a characteristic rho around the loss tangent (tan delta) = 1. In addition, the shapes of the adhesion curves were found to depend strongly on rho, and they were categorized into four types. The different states of cross-linked polymers, i.e., elastic-gel type, weak-gel type, and solution type, showed the different shapes. In the case of the weak gel, two types of characteristic adhesion curves were obtained, which resulted from the different separation mechanisms with and without cavitations near the surface due to the interface and cohesive failures. In the intermediate range of rho, viscous or elastic fingering was detected, which resulted in the characteristic shape of the adhesion curve. The factors determining the type of the adhesion curves are discussed in terms of the microscopic surface, bulk properties, and the different shapes of the adhesive front at the contact surface.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.