Rechargeable batteries with solid polymer electrolytes (SPEs), Li-metal anodes, and high-voltage cathodes like LiNi x Mn y Co z O 2 (NMC) are promising next-generation high-energy-density storage solutions. However, these types of cells typically experience rapid failure during galvanostatic cycling, visible as an incoherent voltage noise during charging. Herein, two imidazolium-based zwitterions, with varied sulfonate-bearing chain length, are added to a poly(ε-caprolactone- co -trimethylene carbonate):LiTFSI electrolyte as cycling-enhancing additives to study their effect on the electrochemical stability of the electrolyte and the cycling performance of half-cells with NMC cathodes. The oxidative stability is studied with two different voltammetric methods using cells with inert working electrodes: the commonly used cyclic voltammetry and staircase voltammetry. The specific effects of the NMC cathode on the electrolyte stability is moreover investigated with cutoff increase cell cycling (CICC) to study the chemical and electrochemical compatibility between the active material and the SPE. Zwitterionic additives proved to enhance the electrochemical stability of the SPE and to facilitate improved galvanostatic cycling stability in half-cells with NMC by preventing the decomposition of LiTFSI at the polymer–cathode interface, as indicated by X-ray photoelectron spectroscopy (XPS).

Solid polymer electrolytes mainly based on polyethers have been actively investigated for over 40 years to develop safe, light, and flexible rechargeable batteries. Here, we report novel supramolecular electrolytes (SMEs) composed of polyether derivatives and a two-dimensional boroxine skeleton synthesized by the dehydration condensation of 1,4-benzenediboronic acid in the presence of a polyether with amines on both chain ends. The formation of SMEs based on polyether derivatives and boroxine skeleton was confirmed by Fourier transform infrared (FT-IR) spectroscopy, X-ray photoelectron spectroscopy (XPS), powder X-ray diffraction (PXRD), and thermogravimetric (TG) analysis. Linear sweep voltammetry (LSV) and cyclic voltammetry (CV) were performed to evaluate the electrochemical stability and lithium conductive properties of SMEs with given amounts of lithium bis(trifluoromethylsulfonyl)amide (LiTFSA). The ionic conductivity of SME/LiTFSA composites increased with increasing lithium-salt concentration and reached a maximum value at a higher concentration than those of simple polyether systems. The lithium-ion transference number (tLi+) of SME/LiTFSA was higher than those of polyether electrolytes. This tendency is unusual for a polyether matrix. SME/LiTFSA composite electrolytes exhibited a stable lithium plating/striping process even after 100 cycles. The current density increased with an increasing number of cycles. The combination of ion conductive polymers and a two-dimensional boroxine skeleton will be an interesting concept for developing solid electrolytes with good electrochemical properties.