No abstract

Besides the opioids the standard management of the World Health Organization suggests NSAIDs (non-steroidal anti-inflammatory drugs) alone or in combination to enhance analgesia in malignant and non-malignant pain therapy. The applicability of NSAIDs in a nasal formulation is a new approach in pharmaceutical technology. In order to enhance the nasal absorption of meloxicam (MX) as an NSAID, its salt form, meloxicam potassium monohydrate (MXP), registered by Egis Plc., was investigated in comparison with MX. The physico-chemical properties of the drugs (structural analysis, solubility and dissolution rate) and the mucoadhesivity of nasal formulations were controlled. In vitro and in vivo studies were carried out to determine the nasal applicability of MXP as a drug candidate in pain therapy. It can be concluded that MX and MXP demonstrated the same equilibrium solubility at the pH5.60 of the nasal mucosa (0.017mg/ml); nonetheless, MXP indicated faster dissolution and a higher permeability through the synthetic membrane. The animal studies justified the short T value (15min) and the high AUC of MXP, which is important in acute pain therapy. It can be assumed that the low mucoadhesivity of MXP spray did not increase the residence time in the nasal cavity, and the elimination from the nasal mucosa was therefore faster than in the case of MX. Further experiments are necessary to prove the therapeutic relevance of this MXP-containing innovative intranasal formulation.

Nowadays, the intranasal route has become a reliable alternative route for drug administration to the systemic circulation or central nervous system. However, there are no official in vitro diffusion and dissolution tests especially for the investigation of nasal formulations. Our main goal was to study and compare a well-known and a lesser-known in vitro permeability investigation method, in order to ascertain which was suitable for the determination of drug permeability through the nasal mucosa from different formulations. The vertical diffusion cell (Franz cell) was compared with the horizontal diffusion model (Side-Bi-Side). Raw and nanonized meloxicam containing nasal dosage forms (spray, gel and powder) were tested and compared. It was found that the Side-Bi-Side cell was suitable for the investigation of spray and powder forms. In contrast, the gel was not measurable on the Side-Bi-Side cell; due to its high viscosity, a uniform distribution of the active substance could not be ensured in the donor phase. The Franz cell, designed for the analysis of semi-solid formulations, was desirable for the investigation of nasal gels. It can be concluded that the application of a horizontal cell is recommended for liquid and solid nasal preparations, while the vertical one should be used for semi-solid formulations.

Abstract:The nasal route receives a great deal of attention as a non-invasive method for the systemic administration of drugs. For nasal delivery, specific formulations containing excipients are used. Because of the sensitive respiratory mucosa, not only the active ingredients, but also additives need to be tested in appropriate models for toxicity. The aim of the study was to measure the cytotoxicity of six pharmaceutical excipients, which could help to reach larger residence time, better permeability, and increased solubility dissolution rate. The following excipients were investigated on RPMI 2650 human nasal septum tumor epithelial cells: β-D-mannitol, sodium hyaluronate, α and β-cyclodextrin, polyvinyl alcohol and methylcellulose. 3-(4,5-dimethyltiazol-2-yl)-2,5-diphenyltetrazolium bromide (MTT) dye conversion assay and real-time impedance analysis were used to investigate cytotoxicity. No excipient showed toxicity at 0.3% (w/v) concentration or below while 1% concentration a significantly reduced metabolic activity was measured by MTT assay for methylcellulose and cyclodextrins. Using impedance measurements, only β-cyclodextrin (1%) was toxic to cells. Mannitol at 1% concentration had a barrier opening effect on epithelial cells, but caused no cellular damage. Based on the results, all additives at 0.3%, sodium hyaluronate and polyvinyl alcohol at 1% concentrations can be safely used for nasal formulations.