This study examined the changes in the properties of beech wood (Fagus sylvatica L.) after intense drying. Beech wood with false red heartwood was selected as the test specimen. The test samples had dimensions of 50 mm thickness, 180 mm width, and 350 mm length. The specimens were divided into two groups, false red heartwood and sapwood. These specimens were selected with different angles of the growth rings (radial and tangential). The results showed that samples with red heartwood, in comparison to samples with sapwood content, had a remarkable effect in covering. Observation of specimens with false red heartwood and sapwood before and after drying process revealed significant differences in color changes and measured values during the covering-slicing test, but not between samples with different growth ring angles.

Structure of wood can affect intensity of color change in remarkable ways. This article was focused on the analysis of the color changes red false heartwood and mature wood by different methods such as ∆E* (Total color difference), h* (Hue angle), C* ab (Color saturation) and S ab (Saturation). The aim of this study was to evaluate the color properties of red false heartwood and mature wood by using different chromacity coordinates. Our observations suggested that the density in the absolute dry state was equal between the red false heartwood and mature wood. The biggest difference was in the area of the free water domain, thus from an initial MC value to the fiber saturation point (FSP). The shorter drying time of the red false heartwood samples was caused by their lower initial MC. Due to the different MC, the temperature created a different color intensity of the compared samples. Mature wood samples achieved more saturated color in the drying process than did the samples of red false heartwood.

No abstract

No abstract

The technology of high temperature drying has a great influence on dimensional and selected physical changes in tension wood. Article is focused on the measurement properties such as moisture content, color changes and longitudinal warping. The quality of beech wood is determined based on structure and properties of wood, frequency of defects in wood material. The tension wood is considered as an important wood defect causing negative alterations in solid wood quality and limits industrial application of wood. The different values of longitudinal warping which were measured after drying were higher in tension wood than in normal wood. Impact of radial and tangential angle of growth rings is non-significant factor.