The aim of the study was to investigate the effect of ethnicity, gender and age on the degree of clenching force and distribution of the load over the dentition. The maximal clenching force was measured in 12 young Danish females, 12 young Japanese females, 12 young Japanese males and 10 senior Japanese males using the Dental Prescale System. The occlusal contact area, average pressure, occlusal load, antero-posterior and right-left location of the occlusal load center (i.e., a center of balance of the occlusal load distributed over the maxillary dentition: OLC) and dental arch length and width were analyzed and compared. The arch width and average pressure in young Danish females were significantly smaller/lower than in Japanese females. The arch length, arch width, contact area and total occlusal load in young Japanese males were significantly greater than those of the Japanese females. The average pressure in young Japanese males was also greater than in senior males. The location of the OLC was almost the same in all groups. The results suggest that the analysis of the OLC may be a useful method for evaluating occlusal function and prosthodontic treatment because the location of the OLC is not affected by ethnicity, gender and age.

The aim of this study was to create a standard for occlusal support in the diagnosis and evaluation of prosthetic treatment. In experimental occlusion, the maximal bite force of eight normal dentates was measured by pressure-sensitive film over the whole dentition using splints divided into nine pieces. The occlusal contact was altered by exchanging splint pieces according to the shortened dental arch concept. The occlusal load center (OLC) was located on a graph set up with reference to the size of the individual dental arch. The occlusal supporting index (SI) and the rehabilitation index (RI) were calculated from the locations of the OLC corresponding to each occlusal contact. Differences in numbers and distribution of occlusal stops could clearly be distinguished by the location of the OLC. Though the SI showed a strong positive correlation with maximal bite force, it is proposed that the number of occlusal stops, or occlusal units, provides the most effective index for quantitative parameters of occlusal support in clinical use. From the standpoint of bite force, analysis of the RI is suggested as a useful method of objectively evaluating the recovery of occlusal support with prosthetic treatment.

No abstract

No abstract

No abstract