The development of a biodegradable material with antimicrobial properties for local applications is required in the prevention and treatment of infectious diseases. The objective of this study was to produce blends of poly-L-lactide acid (PLLA) synthetic polymer associated with several antimicrobials, as an alternative in the prevention and treatment of infections, as well as to evaluate its cytotoxicity, release of antimicrobials and inhibit bacteria growth. Blends of PLLA added with 20% Amoxicillin, Metronidazole, Clindamycin or Azithromicyn were used to produce Films (F) or Meshs (M) by casting and electrospinning methods, respectively. Standardized discs of the films and meshs were stored in buffer solutions (pH 5 or 7.4) and aliquots were analyzed by high performance chromatography (HPLC) during 168 hours. Cytotoxicity on human gingival fibroblasts was tested after 24, 48 and 72h by MTT reaction. The antimicrobial capacity was determined against P. gingivalis and S. pyogenes. The specimens were weighed after 3 and 6 months of storage for degradation analysis. SEM was performed to control interfaces and degradation. Antimicrobials presented a continuous and exponential drug release. Analysis showed that both M and F were able to inhibit S. pyogenes and P. gingivalis growth, indicating the release of active antimicrobial agents. The products were not toxic to the fibroblasts. Amoxicillin-film showed more degradation than PLLA at both pHs (p < 0.05), whereas Azithromycin-meshes were more degraded than PLLA at pH 7.4 (p < 0.05). PLLA association with antimicrobials is biocompatible and may represent a potential tool for the local delivery of antimicrobials.

Lage TC. In vitro analysis of cytotoxicity in osteoblasts of polymer devices incorporated with antimicrobials for local use [dissertation] São Paulo: Universidade de São Paulo, Faculdade de Odontologia; 2017. Versão Corrigida. Osteoblasts are mesenquima originated cells, which are involved in the bone formation. These cells may suffer alterations due to traumas, interventions and infeccions. The infections can be minimized by the handling of antimicrobials. Poly (L-lactide) or PLLA is a synthetic polymer known for its biocompatibility and absorption, which can be used as a local pharmacological releaser, as an alternative to the systemic antimicrobial therapy. This polymer also can be frequently used as a supporting structure to cellular matrix in the bone tissue engineering as it can be used for support in repair and regeneration. The particle incorporation in this polymer can create side effects, therefore, we need to certificate that the polymeric device incorporated with antimicrobials are not cytotoxic. Proposition: Analyse the structure and cytotoxicity in osteoblasts of PLLA polymeric devices associated with antimicrobials, being them: Amoxicillin, Azithromycin, Clindamycin and Metronidazole. Methods: For this study 270 polymerical devices were manufactured with 6mm diameter of PLLA with a 20% antimicrobials incorporation of Amoxicillin (AM), Azithromycin (AZ), Clindamycin (CL) and Metronidazole (ME) that have been produced through two methods: eletrospinning (mesh) or casting (film). Afterwards a MTT cytotoxicity test was made over the periods of 24, 48 and 72 hours of experiment. To make a structural analysis of the device a macroscopic analysis was performed through photographs and microscopic imaging with scanning electron microscope (SEM). Results: The cytotoxicity reaction exhibited that meshes and films incorporated with antimicrobials are comparable with the osteoblasts culture, indicating that there was no cytotoxicity in any moment (p < 0.05). In the phothograph we could observe that the devices showed a similar coloration among the meshes and different coloration for the films depending on the incorporated antimicrobial. The SEM analysis displayed a difference in the surface appearance of the films. The AM films displayed an irregular and porous appearance, meanwhile, AZ looked smooth with few grains, the CL and ME have rough surfaces and PLLA presents smooth surfaces. As for the meshes, we noticed that all the samples had microfibers and pores that mimic the extracellular matrix, differing only in the thickness of the fibers. Osteoblasts were present in all films but AM did not induce proliferation, with only isolated cells emerging. In meshes osteoblasts were only found in AM, ME and PLLA. Conclusion: Polymeric devices made with PLLA incorporated with antimicrobials can be used in bone repair and regeneration given that they did not offer cytotoxicity for osteoblasts.