In this paper, the seven traditional models of photovoltaic (PV) modules are reviewed comprehensively to find out the appropriate model for reliability. All the models are validated using the Matlab code and graphical comparisons between models are made. The accuracy and convergence of each model is evaluated using the data of manufactured PV panels. Then, a novel model is proposed showing its consistent performance. The three most key parameters of the single-diode model are self-revised to adapt to various types of PV modules. This new method is verified in three types of PV panels’ data measured by the National Renewable Energy Laboratory (NREL), USA. The validated data show promising results when the error RMSEs’ range of the proposed model is under 0.36.

Partial shading conditions (PSC) have negative effects on the operation of photovoltaic (PV) systems. In this paper, a PV array reconfiguration method is developed to minimize power losses of PV arrays under partial shading conditions. The proposed reconfiguration method is based on equalizing the reduction of the short-circuit current of the PV modules in the PV array. Eight state-of-the-art Convolutional Neural Network models are employed to estimate the effect of shading on the short-circuit current of a PV module. These models include LeNet-5, AlexNet, VGG 11, VGG 19, Inception V3, ResNet 18, ResNet 34, and ResNet 50. Among eight models, the VGG 19 achieves the best accuracy on 1842 sample images. Therefore, this model is used to estimate the ratio of the actual short-circuit current and the estimated short-circuit current in four studied shading scenarios. This ratio decides the switching rule between PV modules throughout the PV array under PSC. A 2×2 experimental PV array shows that the proposed reconfiguration method improves the output power from 5.81% to 25.19% in four shading patterns. Accordingly, the power losses are reduced from 1.32% to 13.75%. The power improvement and the reduction of power losses of the proposed dynamic PV array reconfiguration system under four case studies demonstrates its effectiveness in addressing the effects of PSC on the PV array.

In this paper, the seven traditional models of PV modules are reviewed comprehensively to find out the appropriate model to be reliable. All the models are validated using the Matlab code and make a graphical comparison. The accuracy and convergence of each model are evaluated using data of manufactured PV panels. Then, a novel model is proposed showing its consistent performance. The most three key parameters of single-diode model are self revised to adapt to various type of PV modules. This new method is verified in three types of PV panels' data measured by National Renewable Energy Laboratory (NREL), US. The validated data show promising results when the error RMSEs' range of the proposed model is under 0.36.

The operation of the photovoltaic (PV) system under partial shading conditions (PSC) is complicated since the output characteristic of the PV system is profoundly affected by the heterogeneous irradiance of PSC. This paper proposes a dynamic reconfiguration framework to tackle PSC in the PV array. Continuous operation of the dynamic PV array reconfiguration under cloud-induced partial shading is considered by developing an emulator of the moving cloud. In addition, the Particle Swarm Optimization and Rao algorithms are improved to obtain the optimal PV array configuration under PSC. The operation of switching is enhanced by simultaneously considering the total switching times and the operation of highly active switches. The simulation results on the 9×9 PV array demonstrate the effectiveness of the proposed framework in terms of reducing the number of local maximum power points on the power-voltage characteristic, enhancing power output, and relieving stress on the switching operation of the PV array under different PSC.