Restrictions on the use of polybrominated diphenyl ethers (PBDEs) have resulted in the increased use of alternate flame retardant chemicals to meet flammability standards. However, it has been difficult to determine which chemical formulations are currently being used in high volumes to meet flammability standards since the use of flame retardant formulations in consumer products is not transparent (i.e. not provided to customers). To investigate chemicals being used as replacements for PentaBDE in polyurethane foam, we analyzed foam samples from 26 different pieces of furniture purchased in the United States primarily between 2003 and 2009 using gas chromatography mass spectrometry. Samples included foam from couches, chairs, mattress pads, pillows, and, in one case, foam from a sound proofing system of a laboratory grade dust sieve. Fifteen of the foam samples contained the flame retardant tris(1,3-dichloro-2-propyl) phosphate (TDCPP; 1-5% by weight), four samples contained tris(1-chloro-2-propyl) phosphate (TCPP; 0.5 -2.2 % by weight), one sample contained brominated chemicals found in a new flame retardant mixture called Firemaster 550 (4.2% by weight), and one foam sample collected from a futon likely purchased prior to 2004 contained PentaBDE (0.5% by weight). Due to the high frequency of detection of the chlorinated phosphate compounds in furniture foam, we analyzed extracts from 50 house dust samples collected between 2002 and 2007 in the Boston, MA area for TDCPP, TCPP, and another high volume use organophosphate-based flame retardant used in foam, triphenylphosphate (TPP). Detection frequencies for TDCPP and TPP in the dust samples were >96% and were log normally distributed, similar to observations for PBDEs. TCPP was positively detected in dust in only 24% of the samples, but detection was significantly limited by a co-elution problem. The geometric mean concentrations for TCPP, TDCPP and TPP in house dust were 570, 1890, and 7360 ng/g, respectively, and maximum values detected in dust were 5490, 56,080 and 1,798,000 ng/g, respectively. These data suggest that levels of these organophosphate flame retardants are comparable, or in some cases, greater than, levels of PBDEs in house dust. The high prevalence of these chemicals in foam and the high concentrations measured in dust (as high as 1.8 mg/g), warrant further studies to evaluate potential health effects from dust exposure, particularly for children.

Due to the voluntary withdrawals and/or bans on the use of two polybrominated diphenyl ether (PBDE) commercial mixtures, an increasing number of alternate flame retardant chemicals are being introduced in commercial applications. To determine if these alternate BFRs are present in indoor environments, we analyzed dust samples collected from 19 homes in the greater Boston, MA area during 2006. Using pure and commercial standards we quantified the following brominated flame retardant chemicals using GC/ECNI-MS methods: hexabromocyclododecane (sigma HBCD), bis(2,4,6,-tribromphenoxy)ethane (BTBPE), decabromodiphenyl ethane (DBDPE), and the brominated components found in Firemaster 550 (FM 550): 2-ethylhexyl 2,3,4,5-tetrabromobenzoate (TBB) and (2-ethylhexyl)tetrabromophthalate (TBPH), the latter compound being a brominated analogue of di(2-ethylhexyl)phthalate (DEHP). The concentrations of all compounds were log-normally distributed and the largest range in concentrations was observed for HBCD (sum of all isomers), with concentrations ranging from <4.5 ng/g to a maximum of 130,200 ng/g with a median value of 230 ng/g. BTBPE ranged from 1.6 to 789 ng/g with a median value of 30 ng/g and DBDPE ranged from <10.0 to 11,070 ng/g with a median value of 201 ng/g. Of the FM 550 components, TBB ranged from <6.6 to 15,030 ng/g with a median value of 133 ng/g; whereas TBPH ranged from 1.5 to 10,630 ng/g with a median value of 142 ng/g. Furthermore, the ratio of TBB/TBPH present in the dust samples ranged from 0.05 to 50 (average 4.4), varying considerably from the ratio observed in the FM 550 commercial mixture (4:1 by mass), suggesting different sources with different chemical compositions, and/or differential fate and transport within the home. Analysis of paired dust samples collected from different rooms in the same home suggests HBCD, TBB, and TBPH are higher in dust from the main living area compared to dust collected in bedrooms; however, BTBPE and DBDPE levels were comparable between rooms. This study highlights the fact that numerous types of brominated flame retardants are present in indoor environments, raising questions about exposure to mixtures of these contaminants.