Indoor shrimp aquaculture systems can be used to produce fresh, never-frozen, quality shrimp near metropolitan seafood markets regardless of season and climate. However, questions still remain regarding what type of production system is best suited to maximize indoor production. In this project, two types of systems were compared: clearwater (CW) RAS and biofloc (BF) systems. Three, 1.36 m 3 tanks were assigned to each of the two treatments; CW tanks had external settling chambers, two foam fractionators, and external biofilters, all operated continuously. BF tanks had settling chambers and one foam fractionator which were operated as needed to control solids accumulation. Shrimp weighing 0.42 g were stocked in all tanks at 250 m-3 and grown for 55 days. Ammonia and pH levels were significantly (P < 0.05) higher in the CW treatment, while nitrite, nitrate, and turbidity were all significantly higher in the BF treatment, although all parameters remained within acceptable ranges for shrimp growth. Shrimp mean harvest weight was significantly higher, biomass (kg m-3) was significantly greater, and FCR was significantly lower in the CW treatment; there were no significant differences in survival between treatments. Isotope levels indicated that shrimp in the BF treatment obtained a portion of the C (18-60%) and N (1-18%) in their tissues from biofloc material; however, this effect did not positively influence production in that treatment. By nearly eliminating solids from the water and using an external biofilter, substantially better water quality was maintained in the CW systems, which may have been a major contributor to the improved shrimp production in that treatment.
Abstract. Damage to a nuclear reactor's materials by high-energy neutrons causes changes in the ductility and fracture toughness of the materials. The reactor vessel and its associated piping's ability to withstand stress without brittle fracture are paramount to safety. Theoretically, the material damage is directly related to the displacements per atom (dpa) via the residual defects from induced displacements. However in practice, the material damage is based on a correlation to the high-energy (E > 1.0 MeV) neutron fluence. While the correlated approach is applicable when the material in question has experienced the same neutron spectrum as test specimens which were the basis of the correlation, this approach is not generically acceptable. Using Monte Carlo and discrete ordinates transport codes, the energy dependent neutron flux is determined throughout the reactor structures and the reactor vessel. Results from the models provide the dpa response in addition to the highenergy neutron flux. Ratios of dpa to fast fluence are calculated throughout the models. The comparisons show a constant ratio in the areas of historical concern and thus the validity of the correlated approach to these areas. In regions above and below the fuel however, the flux spectrum has changed significantly. The correlated relationship of material damage to fluence is not valid in these regions without adjustment. An adjustment mechanism is proposed.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
customersupport@researchsolutions.com
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.