There is much interest in attaching polyethylene glycol (PEG) and other hydrophilic, neutral polymers to surfaces to reduce the extent of protein and cell adsorption. Interestingly, these same surface-bound polymers are effective in masking surface charge and reducing electrokinetic effects such as particle electrophoretic mobility, streaming potential, and electroosmosis. It is apparent that similar molecular properties are responsible for both protein and cell rejection and reduction of electrokinetic effects. In this work we compared the fibrinogen-rejecting ability and the effect on electrophoretic mobility of three polymer coatings bound to polystyrene. The three polymers were side-bound dextran, end-bound dextran, and end-bound PEG. The results of these measurements were used to elucidate the importance of polymer packing density and polymer layer thickness on protein adsorption and reduction of electrokinetic effects. Protein adsorption appears not to be sensitive to polymer layer thickness or the presence of dilute polymer tails in a surface coating, while electrokinetic effects are. Protein adsorption is, however, very sensitive to the availability of exposed surface. Finally, the unique effectiveness of PEG is apparent in this research as in previous studies.

Abstract. Glycidyl esters of epoxidized fatty acids derived from soybean oil (EGS) and linseed oil (EGL) have been synthesized to have higher oxirane content, more reactivity and lower viscosity than epoxidized soybean oil (ESO) or epoxidized linseed oil (ELO). The EGS and ESO, for comparison, were used neat and in blends with diglycidyl ether of bisphenol A (DGEBA). Thermosetting resins were fabricated with the epoxy monomers and either BF 3 catalyst or anhydride. The curing behaviors, glass transition temperatures, crosslink densities and mechanical properties were tested. The results indicated that polymer glass transition temperatures were mostly a function of oxirane content with additional influence of glycidyl versus internal oxirane reactivity, pendant chain content, and chemical structure and presence of saturated components. EGS provided better compatibility with DGEBA, improved intermolecular crosslinking and glass transition temperature, and yielded mechanically stronger polymerized materials than materials obtained using ESO. Other benefits of the EGS resin blend systems were significantly reduced viscosities compared to either DGEBA or ESO-blended DGEBA counterparts. Therefore, EGS that is derived from renewable sources has improved potential for fabrication of structural and structurally complex epoxy composites, e.g., by vacuum-assisted resin transfer molding.

No abstract

The interface between the polymer and the particle has a critical role in altering the properties of a composite dielectric. Polymer-ceramic nanocomposites are promising dielectric materials for many electronic and power devices, combining the high dielectric constant of ceramic particles with the high dielectric breakdown strength of a polymer. Self-assembled monolayers of electron rich or electron poor organophosphate coupling groups were applied to affect the filler-polymer interface and investigate the role of this interface on composite behavior. The interface has potential to influence dielectric properties, in particular the leakage and breakdown resistance. The composite films synthesized from the modified filler particles dispersed into an epoxy polymer matrix were analyzed by dielectric spectroscopy, breakdown strength, and leakage current measurements. The data indicate that significant reduction in leakage currents and dielectric losses and improvement in dielectric breakdown strengths resulted when electropositive phenyl, electron-withdrawing functional groups were located at the polymer-particle interface. At a 30 vol % particle concentration, dielectric composite films yielded a maximum energy density of ~8 J·cm(-3) for TiO2-epoxy nanocomposites and ~9.5 J·cm(-3) for BaTiO3-epoxy nanocomposites.

No abstract