The instrument described here is an all-electronic dielectrophoresis (DEP) cytometer sensitive to changes in polarizability of single cells. The important novel feature of this work is the differential electrode array that allows independent detection and actuation of single cells within a short section ([Formula: see text]) of the microfluidic channel. DEP actuation modifies the altitude of the cells flowing between two altitude detection sites in proportion to cell polarizability; changes in altitude smaller than 0.25 μm can be detected electronically. Analysis of individual experimental signatures allows us to make a simple connection between the Clausius-Mossotti factor (CMF) and the amount of vertical cell deflection during actuation. This results in an all-electronic, label-free differential detector that monitors changes in physiological properties of the living cells and can be fully automated and miniaturized in order to be used in various online and offline probes and point-of-care medical applications. High sensitivity of the DEP cytometer facilitates observations of delicate changes in cell polarization that occur at the onset of apoptosis. We illustrate the application of this concept on a population of Chinese hamster ovary (CHO) cells that were followed in their rapid transition from a healthy viable to an early apoptotic state. DEP cytometer viability estimates closely match an Annexin V assay (an early apoptosis marker) on the same population of cells.
To ensure maximum productivity of recombinant proteins it is desirable to prolong cell viability during a mammalian cell bioprocess, and therefore important to carefully monitor cell density and viability. In this study, five different and independent methods of monitoring were applied to Chinese hamster ovary (CHO) cells grown in a batch culture in a controlled bioreactor to determine cell density and/or cell viability. They included: a particle counter, trypan blue exclusion (Cedex), an in situ bulk capacitance probe, an off-line fluorescent flow cytometer, and a prototype dielectrophoretic (DEP) cytometer. These various techniques gave similar values during the exponential growth phase. However, beyond the exponential growth phase the viability measurements diverged. Fluorescent flow cytometry with a range of fluorescent markers was used to investigate this divergence and to establish the progress of cell apoptosis: the cell density estimates by the intermediate stage apoptosis assay agreed with those obtained by the bulk capacitance probe and the early stage apoptosis assay viability measurements correlated well with the DEP cytometer. The trypan blue assay showed higher estimates of viable cell density and viability compared to the capacitance probe or the DEP cytometer. The DEP cytometer measures the dielectric properties of individual cells and identified at least two populations of cells, each with a distinct polarizability. As verified by comparison with the Nexin assay, one population was associated with viable (non-apoptotic) cells and the other with apoptotic cells. From the end of the exponential through the stationary and decline stages there was a gradual shift of cell count from the viable into the apoptotic population. However, the two populations maintained their individual dielectric properties throughout this shift. This leads to the conclusion that changes in bulk dielectric properties of cultures might be better modeled as shifts in cells between different dielectric sub-populations, rather than assuming a homogeneous dielectric population. This shows that bulk dielectric probes are sensitive to the early apoptotic changes in cells. DEP cytometry offers a novel and unique technology for analyzing and characterizing mammalian cells based on their dielectric properties, and suggests a potential application of the device as a low-cost, label-free, electronic monitor of physiological changes in cells.
Dielectric particles flowing through a microfluidic channel over a set of coplanar electrodes can be simultaneously capacitively detected and dielectrophoretically (DEP) actuated when the high (1.45 GHz) and low (100 kHz-20 MHz) frequency electromagnetic fields are concurrently applied through the same set of electrodes. Assuming a simple model in which the only forces acting upon the particles are apparent gravity, hydrodynamic lift, DEP force, and fluid drag, actuated particle trajectories can be obtained as numerical solutions of the equations of motion. Numerically calculated changes of particle elevations resulting from the actuation simulated in this way agree with the corresponding elevation changes estimated from the electronic signatures generated by the experimentally actuated particles. This verifies the model and confirms the correlation between the DEP force and the electronic signature profile. It follows that the electronic signatures can be used to quantify the actuation that the dielectric particle experiences as it traverses the electrode region. Using this principle, particles with different dielectric properties can be effectively identified based exclusively on their signature profile. This approach was used to differentiate viable from non-viable yeast cells (Saccharomyces cerevisiae). V C 2012 American Institute of Physics.
We present a microfluidic device able to electroporate and measure the resultant changes in dielectric properties of single biological cells. The device can measure the dielectrophoresis (DEP) response of the electroporated cell from a few seconds after exposure to electroporating pulses. Studying electroporation at the single cell level can provide insight on the electroporation process as well as a method of differentiating cellular state (e.g. normal and cancerous). Moreover, combining electroporation and dielectric characterization into a single device eliminates the need for post-sample analysis as required in techniques such as fluorescence cytometry. Experiments performed on Chinese hamster ovary (CHO) cells demonstrate the ability of the device to detect changes in the DEP response of individual cells immediately after being exposed to microsecond duration electroporating pulses.
We describe a microfluidic device integrated with a microwave interferometric sensor that is able to simultaneously electroporate and measure the dielectrophoresis (DEP) response of single biological cells. The system can measure changes in dielectric properties of a cell permeabilized using a high-intensity pulsed electric field (PEF) from a few seconds after exposure to the pulses. It provides a mechanism for investigating timedependent changes in the cell membrane and ion flux. Using this device, experiments performed on single Chinese hamster ovary (CHO) cells exposed to microsecond pulsed electric fields show significant changes in their DEP response immediately after exposure.Index Terms -CHO, dielectrophoresis, electroporation, microfluidic, microwave interferometer, pulsed electric field.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
customersupport@researchsolutions.com
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.