International Ocean Discovery Program (IODP) Expedition 352 recovered a high-fidelity record of volcanism related to subduction initiation in the Bonin fore-arc. Two sites (U1440 and U1441) located in deep water nearer to the trench recovered basalts and related rocks; two sites (U1439 and U1442) located in shallower water further from the trench recovered boninites and related rocks. Drilling in both areas ended in dolerites inferred to be sheeted intrusive rocks. The basalts apparently erupted immediately after subduction initiation and have compositions similar to those of the most depleted basalts generated by rapid sea-floor spreading at mid-ocean ridges, with little or no slab input. Subsequent melting to generate boninites involved more depleted mantle and hotter and deeper subducted components as subduction progressed and volcanism migrated away from the trench. This volcanic sequence is akin to that recorded by many ophiolites, supporting a direct link between subduction initiation, fore-arc spreading, and ophiolite genesis

No abstract

The Izu‐Bonin‐Mariana (IBM) fore arc preserves igneous rock assemblages that formed during subduction initiation circa 52 Ma. International Ocean Discovery Program (IODP) Expedition 352 cored four sites in the fore arc near the Ogasawara Plateau in order to document the magmatic response to subduction initiation and the physical, petrologic, and chemical stratigraphy of a nascent subduction zone. Two of these sites (U1440 and U1441) are underlain by fore‐arc basalt (FAB). FABs have mid‐ocean ridge basalt (MORB)‐like compositions, however, FAB are consistently lower in the high‐field strength elements (TiO2, P2O5, Zr) and Ni compared to MORB, with Na2O at the low end of the MORB field and FeO* at the high end. Almost all FABs are light rare earth element depleted, with low total REE, and have low ratios of highly incompatible to less incompatible elements (Ti/V, Zr/Y, Ce/Yb, and Zr/Sm) relative to MORB. Chemostratigraphic trends in Hole U1440B are consistent with the uppermost lavas forming off axis, whereas the lower lavas formed beneath a spreading center axis. Axial magma of U1440B becomes more fractionated upsection; overlying off‐axis magmas return to more primitive compositions. Melt models require a two‐stage process, with early garnet field melts extracted prior to later spinel field melts, with up to 23% melting to form the most depleted compositions. Mantle equilibration temperatures are higher than normal MORB (1,400 °C–1,480 °C) at relatively low pressures (1–2 GPa), which may reflect an influence of the Manus plume during subduction initiation. Our data support previous models of FAB origin by decompression melting but imply a source more depleted than normal MORB source mantle.

The Erris Trough is a narrow, elongate, Mesozoic basin lying adjacent to the eastern margin of the Rockall Trough to the northwest of Ireland. Limited drilling in the area has proven Carboniferous, Permo-Triassic, Lower–Middle Jurassic and Cretaceous sediments beneath a thin Tertiary cover. Considerable variation in structural style and preserved stratigraphy is observed along the basin. Based on interpreted fault polarity and observed pre-Cretaceous stratal dip, the Erris Trough can be subdivided into three structural sub-basins separated by diffuse, poorly defined, overlapping or divergent transfer zones.Carboniferous basin development in the area of the Erris Trough was significant but is poorly constrained. Permo-Triassic rifting produced a series of half-graben, some of which were controlled by down-to-the-southeast faults. This extensional phase was followed by post-rift subsidence during the Early and Middle Jurassic. In addition, N–S and NW–SE faults locally influenced depositional patterns. In the southern part of the Erris Trough a Middle to Late Jurassic rifting event produced a reversal of the earlier basin geometry with the generation of northwest- and west-downthrowing normal faults. Along the western margin of the Erris Trough, footwall uplift associated with this event induced massive, kilometre scale, uplift and erosion implying Late Jurassic rifting within the Rockall Trough. Restricted basins may have been developed in the area during the Cretaceous as a result of ‘ponding’ of deposition to the east of this zone of footwall uplift. A minor extensional phase occurred during the Aptian–Albian resulting in local reactivation of the Late Jurassic faults concurrent with rifting in the Rockall Trough. A westerly tilt of the basin was established during the Late Cretaceous–Early Tertiary caused by downflexing associated with thermal subsidence of the Rockall Trough. Regional uplift and erosion occurred during the Oligocene–Miocene.Basin modelling indicates that Lower Jurassic source rocks may have generated oil during the Early Eocene to Early Miocene, dependent on an elevated geothermal gradient during the Early Tertiary. Late Carboniferous sediments may have generated hydrocarbons at a number of times during the basin’s history.

International Ocean Discovery Program Expedition 352 to the Izu‐Bonin forearc cored over 800 m of basement comprising boninite and boninite‐series lavas. This is the most extensive, well‐constrained suite of boninite series lavas ever obtained from in situ oceanic crust. The boninites are characterized as high‐silica boninite (HSB), low‐silica boninite (LSB), or basaltic boninite based on their SiO2‐MgO‐TiO2 relations. The principal fractionation products of all three series are high‐Mg andesites (HMA). Lavas recovered >250 meters below seafloor (mbsf) erupted at a forearc spreading axis and are dominated by LSB and HMA. Lavas recovered from <250 mbsf erupted off‐axis and are dominated by HSB. The axial and off‐axis lavas are characterized by distinct chemostratigraphic trends in their major, trace, and isotopic compositions. The off‐axis lavas are chemically similar to boninite from the type locality at Chichijima, with concave‐upward rare earth elements patterns. In contrast, the more abundant axial lavas have distinctly light rare earth element‐depleted patterns and represent a new, previously unsampled precursor to the Chichijima‐type boninite lavas. Petrogenetic modeling suggests that the axial lavas formed by fluxing of refractory mantle (likely the residue from forearc basalt extraction), with amphibolite‐facies melt derived from subducting altered oceanic crust. The upper, off‐axis lavas require an additional component of sediment‐derived melt in addition. Both models are consistent with previously published isotopic data.