Based on the principles of classic film tomography, a new digital X-ray device for dental sites was developed and clinically evaluated. The tomosynthesis process produces several slices from a finite number of radiographs taken from different projection angles, obtaining a three-dimensional image of the jaws and teeth. During evaluation of an industrial prototype, a total of 52 tomosynthesis data sets were made covering different anatomic areas. Of those, 32 sets were assessed by ten radiologically experienced dentists. Anatomic regions not shown on conventional intraoral dental films were displayed due to the extraoral sensor. Diagnostic images of high value were mainly achieved within the scope of lateral views and transverse views in the frontal region. Even small structures such as the periodontal ligament could be shown in several planes, resulting in superposition-free representation. The elimination of metal artefacts caused by dental restorations was facilitated. However, improvements can be made in definition and resolution. Views in the sagittal plane and incomplete blurring of the contralateral jaw are difficulties that remain. The tomosynthesis process combined with a planned 3D representation is likely to be well suited for dental radiology. The use of such a device could be much less expensive than computed tomography (CT). Furthermore, it offers higher spatial resolution, exposes patients to less radiation, and could be easily used in daily practice, even chairside.