Techniques for manipulating, separating, and trapping particles and cells are highly desired in today's bioanalytical and biomedical field. The microfluidic chip-based acoustic noncontact trapping method earlier developed within the group now provides a flexible platform for performing cell-and particle-based assays in continuous flow microsystems. An acoustic standing wave is generated in etched glass channels (600 × 61 µm 2) by miniature ultrasonic transducers (550 × 550 × 200 µm 3). Particles or cells passing the transducer will be retained and levitated in the center of the channel without any contact with the channel walls. The maximum trapping force was calculated to be 430 (135 pN by measuring the drag force exerted on a single particle levitated in the standing wave. The temperature increase in the channel was characterized by fluorescence measurements using rhodamine B, and levels of moderate temperature increase were noted. Neural stem cells were acoustically trapped and shown to be viable after 15 min. Further evidence of the mild cell handling conditions was demonstrated as yeast cells were successfully cultured for 6 h in the acoustic trap while being perfused by the cell medium at a flowrate of 1 µL/min. The acoustic microchip method facilitates trapping of single cells as well as larger cell clusters. The noncontact mode of cell handling is especially important when studies on nonadherent cells are performed, e.g., stem cells, yeast cells, or blood cells, as mechanical stress and surface interaction are minimized. The demonstrated acoustic trapping of cells and particles enables cell-or particle-based bioassays to be performed in a continuous flow format.

No abstract

No abstract

In this paper, the further development of a silicon flowthrough microdispenser is described. Previously reported designs of the dispenser used bimorph, and later multilayered, piezoelectric actuator elements for the generation of droplets. The introduction of a multilayered actuator significantly reduced the voltage amplitude needed to dispense droplets. Dispenser properties relevant for chemical analysis systems, e.g., reduced sample volume, internal surface area, and dispersion, were improved by miniaturization of the device. In this paper, a new actuator design, the tripod, is presented to enable further dispenser miniaturization and to facilitate device assembly. Tripod actuators were manufactured using a prototyping process, based on micromilling, for multilayer piezoceramic components. A building technique for miniaturized electrical interconnects, based on microstructured flexible printed circuits, is also suggested in line with the prospect of future miniaturization. The microfluidic properties of the tripod-actuated dispenser were evaluated. Stable droplet generation in the frequency range from 0 to 3 kHz was demonstrated, providing a maximum dispensed flow rate of 7.8 L min.[1210]