The International GNSS Service (IGS) realtime service (RTS) provides access to real-time precise products such as orbits, clocks and code biases, which can be used as a substitute for ultra-rapid products in real-time applications. The true performance of these products can be assessed by the Analysis Centers daily statistics derived from the comparison with IGS rapid products. Additionally, indirect verification is performed by their application to various precise point positioning strategies. Monitoring results and basic descriptions of these products are available at the official RTS Web page (http://rts.igs.org/). We present a more detailed description of RTS products. Information from various sources is collected to provide products application methodology and describe their important features. We provide extended verification of the products using 1 week of real-time correction data. Results are presented separately for GNSS constellations, considering satellite block and type of onboard clock. Comparison with ESA/European Space Operations Centre final products proves the high accuracy of RTS orbits and clocks, which is 5 cm for GPS orbits, 8 cm for GPS clocks, 13 cm for GLONASS orbits and 24 cm for GLONASS clocks. The real-time correction performance is also examined regarding availability and latency. In general, the availability of corrections was beyond 95 % for GPS and beyond 90 % for GLONASS. Since the increasing degradation of product quality with latency is critical for realtime applications, the relation between product latency and accuracy is analyzed. It confirms that high-rate stream update intervals are suitable for the data provided and that the obsolete data should not be used. To avoid this, we propose a method of short-term prediction of RTS corrections that extends the application period of obsolete correction data without a significant loss in orbit quality. Using polynomial fitting, it is possible to forecast the orbit corrections reliably up to 8 min for GPS and 4 min for GLONASS.

No abstract

Abstract. The near real-time (NRT) high resolution water vapour distribution models can be constructed based on GNSS observations delivered from Ground Base Augmentation Systems (GBAS) and ground meteorological data. Since 2008 in the territory of Poland, a GBAS system called ASG-EUPOS (Active Geodetic Network) has been operating. This paper addresses the problems concerning construction of the NRT model of water vapour distribution in the troposphere near Poland. The first section presents all available GNSS and ground meteorological stations in the area of Poland and neighbouring countries. In this section, data feeding scheme is discussed, together with timeline and time resolution. The high consistency between measured and interpolated temperature value is shown, whereas some discrepancy in the pressure is observed. In the second section, the NRT GNSS data processing strategy of ASG-EUPOS network is discussed. Preliminary results show fine alignment of the obtained Zenith Troposphere Delays (ZTDs) with reference data from European Permanent Network (EPN) processing center. The validation of NRT troposphere products against daily solution shows 15 mm standard deviation of obtained ZTD differences. The last section presents the first results of 2-D water vapour distribution above the GNSS network and application of the tomographic model to 3-D distribution of water vapour in the atmosphere. The GNSS tomography model, working on the simulated data from numerical forecast model, shows high consistency with the reference data (by means of standard deviation 4 mm km −1 or 4 ppm), however, noise analysis shows high solution sensitivity to errors in observations. The discrepancy for real data preliminary solution (measured as a mean standard deviation) between reference NWP data and tomography data was on the level of 9 mm km −1 (or 9 ppm) in terms of wet refractivity.

The recent development of the Galileo space segment and the accompanying support of the International GNSS Service (IGS) allows for worldwide Galileo-only positioning. In this study, different techniques of dual-frequency absolute positioning using the fully serviceable Galileo constellation are evaluated for the first time and compared to the performance of GPS positioning. The daily static positioning based on the broadcast ephemeris using Galileo pseudoranges is significantly more accurate than the corresponding GPS solutions, obtaining the accuracy of a few decimeters. In the kinematic mode, the accuracy is better than 10 m and 20 m for the horizontal and vertical components, respectively, which is comparable to that of GPS. Precise absolute positioning using pseudorange and carrier phase Galileo observations combined with IGS Real-Time Service (RTS) or Multi-GNSS Experiment products is not yet as good as the corresponding GPS solutions. In the static mode, the root mean squared error (RMSE) between estimated and reference coordinates does not exceed 0.05 m and 0.06 m for the horizontal and vertical components, respectively. In the kinematic mode, the respective accuracies are better than 0.17 m and 0.21 m. Moreover, we show that both GPS and Galileo pseudorange solutions benefit from the RTS when compared to the broadcast solutions with the improvement in the accuracy between 10 and 59%. Remarkable results are achieved for Galileo Precise Point Positioning (PPP) solutions based on the broadcast ephemeris. In the static mode, the RMSE is 0.07 and 0.10 m for the horizontal and vertical components which is three and two times better, respectively, then the corresponding solutions based on GPS.

The GNSS precise point positioning (PPP) technique requires high quality product (orbits and clocks) application, since their error directly affects the quality of positioning. For real-time purposes it is possible to utilize ultra-rapid precise orbits and clocks which are disseminated through the Internet. In order to eliminate as many unknown parameters as possible, one may introduce external information on zenith troposphere delay (ZTD). It is desirable that the a priori model is accurate and reliable, especially for real-time application. One of the open problems in GNSS positioning is troposphere delay modelling on the basis of ground meteorological observations. Institute of Geodesy and Geoinformatics of Wroclaw University of Environmental and Life Sciences (IGG WUELS) has developed two independent regional troposphere models for the territory of Poland. The first one is estimated in near-real-time regime using GNSS data from a Polish ground-based augmentation system named ASG-EUPOS established by Polish Head Office of Geodesy and Cartography (GUGiK) in 2008. The second one is based on meteorological parameters (temperature, pressure and humidity) gathered from various meteorological networks operating over the area of Poland and surrounding countries. This paper describes the methodology of both model calculation and verification. It also presents results of applying various ZTD models into kinematic PPP in the post-processing mode using Bernese GPS Software. Positioning results were used to assess the quality of the developed models during changing weather conditions. Finally, the impact of model application to simulated real-time PPP on precision, accuracy and convergence time is discussed.