No abstract

The electron spin degree of freedom can provide the functionality of “nonvolatility” in electronic devices. For example, magnetoresistive random access memory (MRAM) is expected as an ideal nonvolatile working memory, with high speed response, high write endurance, and good compatibility with complementary metal-oxide-semiconductor (CMOS) technologies. However, a challenging technical issue is to reduce the operating power. With the present technology, an electrical current is required to control the direction and dynamics of the spin. This consumes high energy when compared with electric-field controlled devices, such as those that are used in the semiconductor industry. A novel approach to overcome this problem is to use the voltage-controlled magnetic anisotropy (VCMA) effect, which draws attention to the development of a new type of MRAM that is controlled by voltage (voltage-torque MRAM). This paper reviews recent progress in experimental demonstrations of the VCMA effect. First, we present an overview of the early experimental observations of the VCMA effect in all-solid state devices, and follow this with an introduction of the concept of the voltage-induced dynamic switching technique. Subsequently, we describe recent progress in understanding of physical origin of the VCMA effect. Finally, new materials research to realize a highly-efficient VCMA effect and the verification of reliable voltage-induced dynamic switching with a low write error rate are introduced, followed by a discussion of the technical challenges that will be encountered in the future development of voltage-torque MRAM.

We investigated the voltage-controlled magnetic anisotropy (VCMA) in an ultrathin Ir-doped Fe layer with a CoxFe1−x termination layer. The VCMA effect depends on the concentration of the CoxFe1−x alloy, and a large VCMA coefficient, as high as −350 fJ/Vm, was obtained with a Co-rich termination layer. First principles calculations revealed that the increased VCMA effect is due not only to the added Co atoms but also to the Fe and Ir atoms adjacent to the Co atoms. Interface engineering using CoFe termination is also effective for recovering the tunneling magnetoresistance while maintaining a high VCMA effect. The developed structure is applicable for voltage-controlled magnetoresistive devices.

We investigated the influence of heavy metal doping at the Fe/MgO interface on the interfacial perpendicular magnetic anisotropy (PMA) and the voltage-controlled magnetic anisotropy (VCMA) in magnetic tunnel junctions prepared by sputtering-based deposition. The interfacial PMA was increased by tungsten doping and a maximum intrinsic interfacial PMA energy, Ki,0 of 2.0 mJ/m2 was obtained. Ir doping led to a large increase in the VCMA coefficient by a factor of 4.7 compared with that for the standard Fe/MgO interface. The developed technique provides an effective approach to enhancing the interfacial PMA and VCMA properties in the development of voltage-controlled spintronic devices.

We study the dynamic switching properties of a nanomagnet under microwave electric field pumping. The periodic modulation of an anisotropy field induced by microwave electric field pumping efficiently excites the uniform magnetization oscillation, allowing for precise control of magnetization switching. Accurate shaping of the pumping voltage waveform also enables us to investigate the transient reaction of magnetization to the relative phase difference of the pumping signal. We demonstrate both experimentally and theoretically the existence of a dead angle in which the uniform oscillation of magnetization is inhibited even though the microwave frequency itself satisfies the conditions of parametric excitation. Our results provide an energy-efficient way of manipulating ultrafast magnetization dynamics in nanomagnetic devices.