A large variety of nanometre-scale devices have been investigated in recent years that could overcome the physical and economic limitations of current semiconductor devices. To be of technological interest, the energy consumption and fabrication cost of these 'nanodevices' need to be low. Here we report a new type of nanodevice, a quantized conductance atomic switch (QCAS), which satisfies these requirements. The QCAS works by controlling the formation and annihilation of an atomic bridge at the crossing point between two electrodes. The wires are spaced approximately 1 nm apart, and one of the two is a solid electrolyte wire from which the atomic bridges are formed. We demonstrate that such a QCAS can switch between 'on' and 'off' states at room temperature and in air at a frequency of 1 MHz and at a small operating voltage (600 mV). Basic logic circuits are also easily fabricated by crossing solid electrolyte wires with metal electrodes.

We describe a nanometer-scale switch that uses a copper sulfide film and demonstrate its performance. The switch consists of a copper sulfide film, which is a chalcogenide semiconductor, sandwiched between copper and metal electrodes. Applying a positive or negative voltage to the metal electrode can repeatedly switch its conductance in under 100 μs. Each state can persist without a power supply for months, demonstrating the feasibility of nonvolatile memory with its nanometer scale. While biasing voltages, copper ions can migrate in copper sulfide film and can play an important role in switching.

Learning abilities are demonstrated using a single solid‐state atomic switch, wherein the formation and dissolution of a metal filament are controlled depending on the history of prior switching events. The strength of the memorization level gradually increases when the number of input signals is increased. Once the filament forms a bridge, electrons flow in a ballistic mode and long‐term memorization is achieved (see figure).